ICES ICR-210 - Alarm Clock Radio Manual
![]()
Overview
![ICES - ICR-210 - Device Overview Device Overview]()
- 1st Alarm Indicator Buzzer
- 1st Alarm Indicator Music
- Volume Increase/Alarm 1 Set
- Volume Decrease/Alarm 2 Set
- Time Set
- Tuning + Button/Hour Button
- Tuning – Button/Minute Button
- Preset Memory Selection
- On Off/Alarm Off Button
- Snooze Indicator
- 2nd Alarm Indicator Radio
- 2nd Alarm Indicator Buzzer
- Sleep Button
- Snooze Button
Radio
- Press the "ON/OFF" button to turn the clock radio on or off.
- Adjust the "TUNING+" or "TUNING-" to select the desired station.
- Press the "VOLUME+" or "VOLUME-" button to adjust the volume.
- Press and hold the "PRE/M+" button until the preset memory display, for example "P01", is blinking. Then you can select the desired preset memory by "VOLUME+" or "VOLUME-" button and press "PRE/M+" button again to store the desired station.
- Now you can recall the preset station by pressing the "PRE/M+" button to select the preset memory.
Setting the Alarm
- You must switch off the radio before you set the alarm time.
- Press and hold the "AL1" button until the Hour display begins to blink.
- You can set the alarm time: Press the "Hour" to adjust the hour and press "Minute" button to adjust the Minute.
- Press the "AL1" button now to store the alarm time.
- Now you can enable the alarm and select to wake up by radio or buzzer by pressing "AL1" in toggle. The LED with music note logo and bell logo stands for waking up by radio or by buzzer respectively. Both LEDs with music note logo and bell logo are off representing to disable the alarm.
- Use the same method to set Alarm 2.
Canceling the Daily Alarm
Press the "ON/OFF" button to stop the alarm. The alarm will operate 24 hours later as per alarm time set.
Disabling the Alarm
Press the "AL1" or "AL2" button in toggle until both LEDs with music note logo and bell logo are off, the alarm is disabled now.
Setting the Clock
- You must switch off the radio before you set the clock time.
- Press and hold the "TIME" button until the display begins to blink, then release the button.
- Press the "HOUR" and "MIN" button to adjust the hour and minute.
- Press the "TIME" button to save time.
Setting the Sleep Time
- Press the "SLEEP" button repeatedly to set the sleep time ( 90, 80, 70, 60, 50, 40, 30, 20, 10 min or OFF ). When the timer is up, radio will be off automatically.
Snooze
To use the snooze, press the "SNOOZE" bar when the alarm is sounding. The alarm will stop temporarily, but will resume sounding after 9 minutes.
NOTES
- The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on apparatus.
- To be completely disconnect the power input, the mains plug of apparatus shall be disconnected from the mains. As the disconnect devices is the mains plug of apparatus.
- The mains plug of apparatus should not be obstructed OR should be easily accessed during intended use.
- Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
- Minimum distances 10cm around the apparatus for sufficient ventilations.
- The ventilation should not be impeded by covering the ventilation openings with items such as newspaper, table-cloths, curtains etc.
- No naked flame sources such as lighted candles should be placed on the apparatus.
- Attention should be drawn to the environmental aspects of battery disposal.
- The use of apparatus in moderate climates.
- The rating label has marked on the bottom panel of the apparatus.
SPECIFICATIONS
Frequency Range: FM 87.5–108 MHz
Power Source: AC 230V ~ 50 Hz, 3W
DC 2 x AAA batteries (For back-up)
Power Output: 300 mW
Germany 0900-1520530 (Local charges)
The Netherlands 0900-23553626 (Local charges + 1 ct P/min)
Belgium 02-6200115 (Local charges)
France 0170480005(Local charges)
![]()
Documents / ResourcesDownload manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download ICES ICR-210 - Alarm Clock Radio Manual
Need help?
Do you have a question about the ICR-210 and is the answer not in the manual?
Questions and answers