Delta T11851 Installation Instructions Manual page 16
Supply elbow, shower mount hand shower, valve trim, rough-in body, 3-port, three and six function diverter rough-in, 3-port, three and six function diverter trim
Hide thumbs
Also See for T11851:
- Installation instructions manual (66 pages) ,
- Manual (58 pages) ,
- User manual (6 pages)
Advertisement
Installation
2
Showerhead and Tub Spout Installation
A.
FOR TUB SPOUT INSTALLATION:
Refer to the installation instructions supplied with your spout. Do not connect deck mount spouts to
in-wall valves. Do not use hand showers connected in lieu of a tub spout to a tub/shower valve. Do not
use PEX tubing for tub spout drop.
B-1
B-2
68883 Rev.F
2
1
3
2
1
1
FOR SHOWERHEAD INSTALLATION:
Apply plumber tape to pipe threads on
both ends of the shower arm (1). To
prevent damage to finish on shower arm,
insert wall end of shower arm into shower
flange (2) before screwing arm into riser
connection.
Thread showerhead (3) onto shower arm.
Do not overtighten showerhead.
Slip-On Installation
The copper tube (1) must be 1/2" nominal
copper. Important: If it is necessary to cut the
copper tube, the end must be chamfered free of
burrs to prevent cutting or nicking O-ring inside
the spout. Slide spout over copper tube flush
with the finished tub or wall surface. Tighten set
screw (2), but do not overtighten.
Iron Pipe Installation
Install threaded pipe nipple (1) to extend past
finished wall. Apply plumber tape to threads on
pipe nipple and screw on tub spout.
4
Advertisement
