Table of Contents
Advertisement
USE AND INSTALLATION MANUAL
4.1.4. REGENERATION MODE
When in stand-by, the display shows the current time and day of the week.
During regeneration, the time indicates the operating phase (C1÷C8) and the regeneration time remaining.
Delayed regeneration
Press the REGEN button,
2:00 by default). The regeneration symbol will flash on the display.
Manual regeneration
Press and hold the REGEN button for 5 seconds
Double regeneration
During regeneration, pressing the REGEN button
progress. X2 will be displayed.
Step-by-step regeneration phase
Press both buttons at the same time and immediately release
displayed, the timer will not accept any commands.
Fast forward automatic phases
When the fixed hourglass is displayed during phase, if the
hourglass will start to flash. In this condition, the timers will automatically switch to service mode by fast forwarding
through all the phases.
Regeneration reset
Press and hold the
4.1.5. TIMER RESET
1. Press and hold SET and DOWN at the
same time for 5 seconds.
2. H0 and set resin volume will be displayed.
3. If a different historic value than "H0" is
shown, use the UP arrow to scroll the
settings until "H0" is displayed.
4. To reset the timer, press and hold SET for 5
seconds.
5. The timer will be reset to a non-programmed
state.
6. Reprogram the timer.
the programmer will perform a regeneration at the next set regeneration time (at
to immediately start regeneration.
forces a second regeneration immediately after the one in
buttons for 5 seconds.
. When the hourglass 17 is
buttons are pressed for 5", the
34
Advertisement
Table of Contents
