How To Control; Remote Controller; Fixture Cleaning - Beamz Mini 4 Head Moon Clear LED Instruction Manual

HOW TO CONTROL

You can control this fixture without the use of a controller because this feature provides automatic and sound activated mode.

REMOTE CONTROLLER

1. ON/OFF
2. Flash strobe
3. Auto mode
4. Speed +
5. Speed -
6. Sound activate mode
7. Sensitivity +
8. Sensitivity -
The remote control is supplied with a battery inserted. An insulating foil
between the battery and the battery contacts prevents the battery from
being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control.
Otherwise operation of the remote control is not possible.
If the range of the remote control decreases, replace the battery. For this purpose, on the rear side
of the remote control press the small bar with the groove to the right (1) and at the same time
remove the battery support (2). For operation, one 3 V button cell type CR2025 is required. When
inserting, pay attention that the positive pole of the button cell shows upwards in the support.

FIXTURE CLEANING

The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit's optics.

Make sure the area below the installation place is free from unwanted persons during servicing

Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation

The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected

In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.

The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.

Clean with soft cloth using normal glass cleaning fluid.

Always dry the parts carefully.

Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
AUTO: Fixture shown the preset program and adjust the speed sensitivity knob.
SOUND: Fixture responds to the beat of the music. Turn the music on and adjust
the sound sensitivity knob until the product responds to the beat of the music.
5