PLEASE KEEP ME WITH YOUR PROOF OF PURCHASE FOR FUTURE REFERENCE
ATTENTION:
1.
Please read these instructions carefully before assembly
2.
Aluminium is a soft metal and over tightening may strip the thread or break the part
3.
DO NOT use power tools
4.
Please allow 30 minutes for assembly
5.
Although assembly only requires 1 person it is advised that a second person be present to help turn the table over and into position when
fully assembled
ASSEMBLY STEPS:
1.
Turn table top over and put onto a soft clean surface, be careful of the glass fixed on table top and no need to take out of the glass
2.
LOOSELY attach Side panel 1 (B) and Side panel 2 (C) to table top (A) with bolts (K) and big flat washers (M) using Spanner (N) DO
NOT TIGHTEN THE BOLTS AT THIS STAGE
3.
LOOSELY attach rear panel (D) to Side panel 1 & 2 with bolts (K) and big flat washers (M) using Spanner (N)
4.
LOOSELY attach bottom frame (E) to connecting bar (F) with bolts (K) and big flat washers (M) using Spanner (N)
5.
LOOSELY attached assembled bottom frame to Side panel with bolts (L) and big flat washers (M) using Spanner (N)
6.
Tighten all bolts one by one using spanner, being careful not to over tighten any as this will cause the thread to become damaged
7.
Turn table top over and place in desired position, be careful of the glass fixed on table top while turning over the table
8.
Open the door, connect the gas pipe then put the gas tank on the fixed bottom frame and close the door
9.
Pour the bag of glass beads (H) into fire pit
10. Put the centre glass (G) on top of the fire pit
11. Fire guard: fix 4pc glass (I) onto the glass clips (J). Note: When installing the glass clips, the direction of the clip on the same piece of
glass must be in reverse.
12. Put the assembled fire guard on the correct position on table top, the table is assembled completely.
For more information regarding maintenance of your furniture please visit
https://www.hartmanuk.com/home
Component's
Parts List
Parts Picture
A
B
C
D
E
F
G
For replacement or lost spare parts please go to
Should you have any queries about your furniture your first point of contact should be the retailer from whom
you purchased your product
ASSEMBLY INSTRUCTIONS
Sorrento/Bari 115cm Square Gas Firepit with Ceramic Top
(
67009068 / 64513007
Description
Q'ty
Part no
67009068A
Table Top
1
64513007A
with Glass
67009068B
Side panel
1
64513007B
1 with door
67009068C
Side panel
1
64513007C
2
67009068D
Rear panel
1
64513007D
67009068E
Bottom
1
64513007E
frame
67009068F
Connecting
2
64513007F
bar
67009068G
Centre
1
64513007G
glass
http://spares.hartmanuk.co.uk/purchase
)
Fixings
Parts list
Parts Picture
H
I
J
K
L
M
N
Description
Q'
Part no.
ty
67009068H
Glass
1
64513007H
beads
67009068I
Fire Guard
4
64513007I
Glass
21000042
Glass clip
8
1231162
M6*25mm
12
bolts
2100040
M6*35mm
4
bolts
1061162
Flat
16
washers
2100041
Spanner
1
Need help?
Do you have a question about the Sorrento and is the answer not in the manual?
Questions and answers