LG FHD0905SWS Owner's Manual page 17

• No further backflow protection required for
connection to the water inlet.
Checking the Rubber Seal
Two rubber seals are supplied with the water
a
supply hose. They are used to prevent water leaks.
Connection to taps is sufficiently tight.
• Do not use mechanical devices such as multi
grips to tighten the water supply hose. Ensure
that the curved end of the water supply hose is
connected to the appliance.
Connecting the Hose to the
Water Tap
1
Unscrew the adapter ring plate
the 4 fixing screws.
2
Remove the guide plate
to fit the adapter.
and loose
a
if the tap is too large
b
3
Push the adapter onto the end of the tap so
that the rubber seal is connected to be
watertight. Tighten the 4 fixing screws and the
adapter ring plate.
4
Pull the connector latch plate
the inlet hose onto the adapter, and release the
connector latch plate. Make sure the adapter
locks into place.
NOTE
• After connecting the water inlet hose to the
water tap, turn on the water tap to flush out
foreign substances (dirt, sand, sawdust, and etc.)
in the water lines. Let the water drain into a
bucket, and check the water temperature.
INSTALLATION
down, push
c
17