Assembly Instructions - Texas A/S Hobby 500 B/TG Instruction Manual

The machine should not be used by anyone under the age of 18.
The machine should only be lent to persons who know how to use it. Always
make sure they have the manual as well.
The cultivator should only be used by fit and healthy persons individuals. If you
get tired, take frequent breaks.
Never use the machine after drinking alcohol.
The factory-fitted control units, such as the gear cable from the handle, must not
be removed or covered.
Always check that nuts and bolts are tight before starting the machine.
When the engine is running, do not pull the handle for forward gear and the
handle for reverse at the same time! This will damage the transmission. Always
release one handle before the other is used.
Using the machine on steep slopes is dangerous!

Assembly instructions

1. Figure 1 shows the contents of the kit:
a. Blades
b. Tiller with cables
c. Support wheel
d. Side guards
e. Upper handlebar
f. Depth skid
g. Lower handlebars, right and left
h. Mounting bracket for steer
i. User manual
2. Figure 2.
Mount support wheel.
Remove bracket(a). The levers on the bracket must go behind the rear axle.
Mount the bracket over the rear axle to attach the support wheel.
3. Figure 3.
Mount the two lower handlebars with the bolts supplied (c,d). Note that the left and
right handlebars are different. Steer (a.) must be mounted on the right. Steer (b.)
must be mounted on the left.
"Be careful of rotating knives"
Only use the machine in areas where it can be
operated safely!
10