Troubleshooting - Hilti NURON NMX 6-22 Manual

8 Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery/batteries.
▶ Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9

Troubleshooting

If a problem occurs, always observe the charge-status and fault indicator of the battery. See the section
headed Status indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, please contact Hilti Service.
Trouble or fault
The battery runs down more
quickly than usual.
The battery does not engage
with an audible click.
LEDs of the battery show
nothing
The drive spindle doesn't
rotate.
Product or battery gets very
hot.
10 English
Possible cause
Battery state of health is not opti-
mal.
Retaining lug on the battery dirty.
Battery faulty.
Battery not fully inserted.
Spindle locking switch is in the
position.
Electrical fault.
Action to be taken
▶ Call up the battery's state of
health. Section headed "Status
indicators of the Li­ion battery"
→ page 6.
▶ Clean the retaining lug and
re-insert the battery.
▶ Contact Hilti Service.
▶ Push the battery in until it
engages with an audible click.
▶ Set the spindle locking switch
to the position.
▶ Immediately switch off the
product. Remove the battery
and keep it under observation.
Allow it to cool down. Contact
Hilti service.
2341692
*2341692*