Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for Comelit SK9011/A
Summary of Contents for Comelit SK9011/A
- Page 1 PAC Remote Transmitter RF Access Control Unit Installation Guide P/N: SK9011/A July 2023 SK9011/A_RF_AC_Install Technical pacgdxsupport@comelit-pac.co.uk Support T: +44 (0)161 406 3400 — Option 2 Customer pacgdxcustomerservice@comelit-pac.co.uk Services T: +44 (0)161 406 3400 — Option 1...
-
Page 2: Important Notes
IMPORTANT NOTES This Comelit product was designed for use with access control and door entry systems in residential, commercial or industrial settings and in public buildings or buildings used by the public. All activities connected to the installation of Comelit products must be carried out by qualified technical personnel, with careful observation of the indications provided in the manuals / instruction sheets supplied with those products. - Page 3 1 Introduction The SK9011/A unit is a radio frequency control unit to be used with radio transmitters SK9062B/A and SK9062Y/A, for the purposes of controlling access to a door fitted with an electronic lock or an automatic device. The RF Unit connects to a PAC 500 series controller with 32-bit Wiegand output.
- Page 4 2 Connect to PAC 500 Series Controller 1. Connect the receiver to the 500 series controller as detailed in the image below. The SK9014 antenna is an optional item that may be required when the transmit distance surpasses 4m (line of sight). 2.
- Page 5 3 Add Transmitter to Software You can add a transmitter to the PAC access control software as long as the transmitter and receiver have not been administered by the Comelit Simple Bus application:: RF Access Control unit must be at factory default.
- Page 6 Use Transmitter as RFID Proximity Credential If the transmitter is to be used as a proximity credential with PAC GS3 MT readers, ensure the following dip switch settings are applied to the reader. This function is only available in readers manufactured with V2.2.0 firmware or later.
-
Page 7: System Reset
4 System Reset If the receiver has either been used previously on a Comelit Simple Bus installation or becomes unresponsive, follow the steps below to reset the unit. Existing transmitters will not need to be re-administrated. 1. Place S2 in programming mode ‘ON’ (LED1 = fixed red) 2. - Page 8 Description of terminals Power supply 12-24 VAC or 12-33 VDC RS485 network (Not required for PAC controller connection) Wiegand output 5: D0 and 6: D1 7-8-9 Relay output C/NC/NO (Not required for PAC controller connection) RTE button (Not required for PAC controller connection) Not used Not used 0V (Not required for PAC controller connection)
-
Page 9: Technical Information
6 Technical Information Power consumption 50 mA when idle, 100 mA when relay active Operating temperature –10°C to +55°C Operating voltage 12V @ 24VAC or 12V at 33VDC Dimensions 55 (h) x 85 (l) x 20 (d) mm Coverage 50m in a free field (indicative) Offset Aerial (Part number SK9014) This antennal can be used to improve the range of the receivers and must be used when the receiver is located within a metal enclosure or is close to large metal...
Need help?
Do you have a question about the SK9011/A and is the answer not in the manual?
Questions and answers