Sapho VE421 VEEN CLEAN Operating Instructions Manual page 12

Drain the water of tank
DANGER
1. Hold the plug with the tipper, turn
„OPEN", and pull out. It will start to drain.
2. After completing the drainage, insert
the plug and turn to „CLOSE".
One-ON-One Setting
-
Install several electronic bidets in the same area, if you want each remote control to control
the specified electronic bidet, please complete setting as per following steps
1. Open both cover and seat and without seating. Set the night light to the „close" model (just see the
„Light setting").
2. Keep pressing the „Stop" button and „Shift" button of adjust temperature on the remote control at the
same time for a few seconds, then hear the „beep" from the product and meanwhile the indicator light
of first steps flicks.
3. Release the „Stop" button, but keep pressing the „Shift" button.
4. Press the „-" and „+" of the flow in order, and then release the „Shift" button. At this time, the lighted
indicator is the current ID code of product, and the 5th step light always flicks.
5. By pressing „-, +" buttons of the flow to change different product ID code with corresponding indicator
lights up. There are 10 ID codes in total. It is on the first code by default and the first step light lights up.
1
AND
/ / / /
1. The water and power must be cut before you disassemble the E-Bidet
2. Do not invert or tilt it before you finish draining the water tank
2
/ / / /
AND
/ /
/ /
3
/ / / / / /
/ /
AND
12
4
/ / / /
OR