Maintenance And Inspection - Hitachi W 6VA3 Instruction Manual And Safety Instructions

English

MAINTENANCE AND INSPECTION

WARNING:
1. Inspecting the hex. socket (or bit):
Since continued use of a worn hex. socket (bit) will damage screw heads, re-
place the hex. socket (bit) with a new one as soon as excessive wear is noticed.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tight-
ened. Should any of the screws be loosened, retighten them immediately.
WARNING:
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power tool. Exercise due care
to ensure the winding does not become damaged and/or wet with oil or water.
4. Cleaning the unit exterior
Wipe off oil and stain on the unit exterior with a dried rag or a rag moistened
with soapy water.
5. Inspecting the carbon brushes
For your continued safety and electrical shock protection, carbon brush inspec-
tion and replacement on this tool should ONLY be performed by a HITACHI AU-
THORIZED SERVICE CENTER.
6. Service and repairs
All quality power tools will eventually require servicing or replacement of parts
because of wear from normal use. To assure that only authorized replacement
parts will be used, all service and repairs must be performed by a HITACHI AU-
THORIZED SERVICE CENTER, ONLY.
14
Be sure to switch power OFF and disconnect the plug from the
receptacle during maintenance and inspection.
Using this screw driver with loosened screws is extremely
dangerous.