Advertisement
other connector to the USB port on a Computer or a USB charging device, or a 5V USB charging adapter(not
included) and plug into a socket.
The LED indicator will turn RED while charging and turn BLUE when fully charged.
A ring will be heard on a lower power, and it indicates that the headset should be charged.
When the headset is with low battery, please use the charging cable to charge and make sure the charging
voltage is 5V/1A.
POWER SAVING
If no successful pairing for 5 minutes, the headset will automatically turn off.
LED INDICATOR STATUS
Charge Status
Pairing Status
Connected Status
Using Status
WARNINGS
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this
device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation。
When charging, LED indicator light stays RED. When fully charged, LED indicator
light turns BLUE.
LED indicator light rapidly alternating flashes BLUE AND RED.
LED indicator light stays BLUE.
Bluetooth Mode, LED indicator light flashes BLUE.
Aux-in Mode, LED indicator goes OFF.
Advertisement
