AEG SatelliteClean 6000 FSB64907Z User Manual page 12

12 www.aeg.com
7.1 Setting mode
How to navigate in setting
mode
You can navigate in setting mode using
MY TIME selection bar.
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch
between the basic settings and to
change their value.
Use OK to enter the selected setting and
to confirm changing its value.
How to enter setting mode
You can enter setting mode before
starting a programme. You cannot enter
setting mode while the programme is
running.
To enter setting mode, press and hold
simultaneously
about 3 seconds.
The lights related to the Previous, OK
and Next are on.
How to change a setting
Make sure the appliance is in setting
mode.
1. Use Previous or Next to select the
bar of the ECOMETER dedicated to
the desired setting.
Water hardness
German de‐
grees (°dH)
47 - 50
43 - 46
A B C
and
French de‐
grees (°fH)
84 - 90
76 - 83
• The bar of the ECOMETER
• The display shows the current
2. Press OK to enter the setting.
• The bar of the ECOMETER
• The current setting value flashes.
3. Press Previous or Next to change
the value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the basic
5. Press and hold simultaneously
seconds to exit setting mode.
The appliance returns to the programme
selection.
The saved settings remain valid until you
change them again.
7.2 The water softener
The water softener removes minerals
from the water supply, which would have
a negative effect on the washing results
and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
for
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water
in your area. Set the right level of the
water softener to assure good washing
results.
mmol/l mg/l (ppm)
8.4 - 9.0 835 - 904
7.6 - 8.3 755 - 834
dedicated to the chosen setting
flashes.
setting value.
dedicated to the chosen setting is
on. The other bars are off.
settings list.
and for about 3
Clarke Water softener
degrees
58 - 63
53 - 57
level
10
9