Advertisement
t)
EBQ Models: IMPORTANT: REVIEW paragraph 8 on page 3: EBQ model QUASAR UV-C LED
OPERATION before proceeding. Failure to follow paragraph 8, Step 5 can damage the QUASAR.
1) Make sure the air is purged from water lines and chiller through fountain bubbler(s).
2) Plug in bottle filler power supply cord in electrical outlet.
3) Place bottle in alcove to dispense water. The Water Dispenser sensor will run for 20 seconds and shut-
off. Do this 2 or 3 times until a steady stream of water dispenses.
u) Where applicable, secure bottom panel(s) top edge(s) behind frame middle cross member(s) and fasten
panel(s) at bottom to frame with flat head screws, provided.
v) Slide reveal gasket(s) back into notch between panel and arm. The gasket serves as an appearance item only
(to close up any opening around panel and mounting plate).
w) Check plumbing connection for leaks. On new plumbing installations, run water through the bubbler(s) until
water taste is satisfactory. Adjust regulator to achieve desired stream height. Add bottom plate(s) back to
fountain arm(s).
8.
EBQ model QUASAR UV-C LED OPERATION
a) QUASAR is a form of dispense point water treatment that utilizes UV-C LED's to inactivate pathogens.
b) Operation:
1) The QUASAR activation is automatic. The UV-C LED's turn ON when water is dispensed and OFF
when the dispense stops.
2) During non-use periods the QUASAR automatically cycles ON for ten seconds every ten minutes. This
keeps the dispense point more sanitary between use.
3) When the QUASAR is ON, the LED light on the front of the alcove near the top will turn ON. The LED
will be BLUE when the QUASAR is working properly.
4) If QUASAR is not working properly, then the LED light on the front of the alcove near the top will be
RED or YELLOW. The light will remain ON and the system will not allow water to be dispensed until
the problem is resolved.
5) IMPORTANT: Never operate the QUASAR without water connected to the system. Lack of water can
cause the QUASAR to overheat. If it is necessary to activate QUASAR to purge the system of air, then
do not activate the QUASAR dry for more than 4-5 seconds at a time. Wait 60 seconds to allow the
QUASAR to "cool" before the next "dry" activation. Dry activations normally occur during initial setup
or during filter changes.
The warranty and the Underwriters' Laboratory Listing for this machine are automatically voided if this machine is
altered, modified, or combined with any other machine or device. Alteration or modification of this machine may
cause serious flooding and/or hazardous electrical shock or fire.
EXCEPT AS SET FORTH HEREIN, THE MANUFACTURER MAKES NO OTHER WARRANTY,
GUARANTEE OR AGREEMENT EXPRESSED, IMPLIED, OR STATUTORY, INCLUDING ANY IMPLIED
WARRANTY OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
This appliance is not intended for use by persons (including children) with reduced physical sensory or mental
capabilities or who lack the experience and knowledge, unless they have been given the supervision or instruction
concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure they
don't play with the appliance.
®
®
OASIS
, QUASAR
, Aqua Pointe
LVD Acquisition, LLC dba Oasis International
OASIS INTERNATIONAL
222 East Campus View Blvd. • Columbus, OH 43235 U.S.A.
1-800-950-3226
www.oasiscoolers.com
®
®
and Versafiller
are registered trademarks of
WARNING
© 2023 LVD Acquisition, LLC
030099-688, 3/2023
3 of 6
Advertisement
