SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. WARNING: • Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. •...
Page 4
2. Drill with a suitable drill bit (7/32 in.) and plug the mounting holes with plastic anchors (BB). 3. Insert the screws (AA) into the mounting holes by using the Phillips screwdriver. 4. Leave 0.2 in. of the screws exposed. Hang the fixture (A) on the two screws (AA).
Page 5
OPERATING INSTRUCTIONS 1. Move the switch to the desired mode. 2. Using ON mode: Light on at night; the sensor is off. 3. Using AUTO mode: Light on when the sensor detects motion. Light off when the motion leaves.
4. Using DIM mode: Light on when the sensor detects motion. Light turns to low brightness when the motion leaves. BATTERY CHANGE 1. Detach the diffusor by unscrewing the screws pre-assembled in the fixture with a Phillips screwdriver. 2. Detach the LED plate by unscrewing the screws on the LED plate with a Phillips screwdriver.
Page 7
3. Take out the old battery from the battery compartment. CAUTION: Batteries must be recycled or destroyed appropriately. 4. Install a new battery (3.7 V 1500 mAh Li-ion). 5. Install the LED plate using the screws removed in step 2.
6. Install the diffusor using the screws removed in step 1. CARE AND MAINTENANCE • To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only. • Periodically clean the solar panel with a soft cloth and warm water. •...
INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE EXCLUSION OR LIMITATION MAY NOT APPLY TO YOU. LUTEC USA LLC: 149B Houston Rd Troutman NC 28166 Ningbo UME Lighting Co., LTD CN8, Far East Industry Park, Yuyao, China Help@umelux.com Printed in China...