Gefu 12330 - Digital-Timer CONTARE Manual

Safety and care instructions

1. Please read the operating instructions thoroughly before first use, keep them for later use and give them to third parties when passing on the digital timer to third parties. This digital timer should not be used by persons (including children) with limited physical, sensory or mental abilities or a lack of a lack of experience and/or lack of knowledge.
2. The guarantee becomes void if the digital timer is tampered with.
3. Never expose the digital timer to direct heat.
4. Always store and use the timer in a dry place.
5. Always keep the device and batteries away from children.
6. Make sure you use the correct type of battery and always insert them in the prescribed pole direction.
7. Only use fresh batteries for replacement and never any with visible damage – overheating or explosions may occur.
8. Never throw used batteries into fire. Danger of explosion!
9. The digital timer's batteries are not rechargeable.
10. Remove the batteries if the digital timer will not be used for a long period of time, in order to prevent damage from possible leaking batteries.
11. Never short-circuit batteries
12. If all indicator elements are flashing, this indicates that the batteries need to be changed

Care instructions:
The Digital Timer CONTARE is not dishwasher-safe. Therefore, do not immerse it in water. The timer can be wiped clean with a damp cloth.

Battery disposal

Batteries do not belong in the household waste. As a consumer you are legally obliged to return used batteries. You can dispose of your old batteries at public collection points in your community or anywhere where the same batteries are sold

Disposal of the digital timer

The symbol on the product or its packaging indicates that this product should not be treated as normal household waste but must be handed in at a collection point for the recycling of electrical and electronic devices. Further information can be obtained from your municipality, the municipal disposal company or the shop where you bought the the product

Purpose and use

Thank you very much for purchasing this device. Precise time monitoring is essential for cooking, grilling, roasting and baking with pinpoint accuracy like a professional. The easy-to-use and effortlessly readable digital timer can be set to the minute and second up to 99 minutes and 59 seconds. With an acoustic signal, the digital timer indicates when the set time has elapsed and thus the desired cooking time has been reached. Counting up is also easily possible with the digital timer. This allows you to always keep an overview of the cooking time, even while you are looking after your guests.
The digital timer is designed for private households only and may not be used for commercial purposes.
Please read the user manual and especially the safety instructions carefully and follow the corresponding care instructions. Please keep the user manual and packaging in a safe place for future reference.

Scope of delivery

1 x 1.5V battery type AAA
User manual

Specifications

• integrated magnet and stand
• easy to read display with 17mm character height
• time setting from 00:00 h - 99:59 h
• incl. battery 1.5V AAA
• dimensions 65 mm x 20 mm x 72 mm (L x W x H)
• weight 40g (without battery)
• plastic and high-grade stainless steel

GEFU Innovation + Logistic GmbH hereby declares that the product 12330 Digital Timer "CONTARE" complies with the essential requirements and applicable regulations of the EMC Directive 2014/30/EU and RoHS Directive 2011/65/EU. The full conformity declaration and this user manual in PDF format is available on the internet at www.gefu.com/k21930.pdf

Display and operating elements

1. Display minutes
2. Display seconds
3. Button minutes
4. Button seconds
5. Start/Stop button

3+4. Reset timer at the same time

First use

1. Insert battery and close battery compartment
2. The display first shows 88M88S (display test) and then 00M00S, while the acoustic signal is heard very briefly.
3. The desired target time between 00M00S and 99M59S can be preset with the two buttons "MIN" and "SEC". If the "MIN" or "SEC" button is pressed only briefly during setting, it only switches upwards by one minute or second. However, if the "MIN" or "SEC" button is pressed and held down for more than two seconds, the timer counts up until the respective button is released again.
4. In the preset mode, the counter can only count down until 00M00S is reached. During counting, the two letters "M" and "S" flash.
5. The timer is always started by pressing the "START/STOP" button once. If it is pressed again while counting down, the timer stops until it is restarted by pressing the "START/STOP" button again.
6. When the time 00M00S is reached, an acoustic signal sounds which can be temporarily switched off either with one of the two buttons "MIN" or "SEC" or with the button "START". If one of the two buttons "MIN" or "SEC" is pressed, the acoustic signal is switched off and the timer display continues to show 00M00S.
   However, if the "Start" button is pressed instead, the acoustic signal is also temporarily switched off, but the display now shows the target time preset under point 3 again, so that the timer can be started again by pressing the "START/STOP" button again to count down the previously set target time.
7. The timer can be reset to 00M00S at any time by pressing the "MIN" and "SEC" buttons simultaneously.
8. However, if the "START" button is pressed instead of "MIN" or "SEC" after switching on or resetting the timer, the timer can only count upwards. Each time the "START" button is pressed again, the timer can be paused at any time and restarted for continuing the counting. In upward mode, it is only possible to start at 00M00S and there is no presettable time or acoustic signal.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Gefu 12330 - Digital-Timer CONTARE Manual