Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for HTC HP-500
- Page 1 HP-500...
-
Page 2: Table Of Contents
MANULA Safety rules and precautions ......................- 1 - Brief introduction ........................- 2 - III. Electrical symbols ........................- 2 - Technical specifications......................- 3 - V. Instrument structure ........................- 4 - Operation method ........................- 5 - Self check and Shutdown .......................... -
Page 3: Brief Introduction
Do not use this instrument for a long time, please take out the battery. Replace the battery, pay attention to the battery polarity. To use, dis-assembly and maintenance of this instrument must be operated by authorized personnel. ... -
Page 4: Technical Specifications
Extremely dangerous! The operator must strictly abide by the safety rules, otherwise there is a risk of electric shock, causing personal injury or casualties. Warning! Safety rules must be strictly observed, otherwise personal injury or equipment damage will be caused IV. -
Page 5: Instrument Structure
Power Max：65mA consumption Weight 365g（ Including battery ） Operating temperature and －10℃～+50℃＜85%RH humidity Storage temperature －15℃～+55℃＜90%RH humidity Low battery When the battery voltage drops to about 5.5V, the low battery voltage signal prompts to replace the battery indicating EN 61326-1 CISPR 11 Safety regulations EN 61000-4-2 EN 61000-4-3 EN 61000-4-8... -
Page 6: Operation Method
1 、 Insulating rod joint 2 、 LED Indicator 3 、 Battery cover 4 、 Light switch 5 、 Buzzer 6 、 Low battery indicator 7 、 Range switch 8 、 LED Light VI. Operation method 1. Self check and Shutdown Rotate the switch to the TEST position, the instrument self checks, the buzzer... -
Page 7: Test
power indicator light of the instrument gives a light prompt, please replace the battery in time. 2. Test Connect the instrument to the insulating rod, turn the switch to the corresponding voltage range to start the test, and then place the LED side of the instrument close to the object to be tested. -
Page 8: Battery Replacement
VII. Battery replacement Warning! If the battery cover plate is not covered properly, it cannot be tested, otherwise it is dangerous. Pay attention to the battery polarity, otherwise the instrument will be damaged. The battery is low, please replace it in time. Do not use the meter for a long time, please take out the battery. - Page 9 - 8 -...
Need help?
Do you have a question about the HP-500 and is the answer not in the manual?
Questions and answers