Master Configuration; Contents; Interactive Menu - Schako EasyS-H01 User Manual

8 Master configuration

8.3.1 Contents

On this screen, you will find all the detailed information about the selected Easy3-M:
• Status: Running, Error...
• Uptime
• Firmware version
• Easy III Settings: The channel used by the master for communication with the slaves
• Cycle time per group (A or B) in milliseconds
• Error Number: Recorded by the system
• Signal strength: From Very Low to Excellent.
• Retry rate: From Very High to Very Low
Screen display

8.3.2 Interactive menu

Clicking on "Advanced"
The system allows you to access the "Master Advanced Config" screen.
For more information, see chapter 8.4 Master Advanced Configuration
Clicking on "Clear Counters"
All recorded retries and errors are deleted for the selected master
After clicking on "Highlight Network", the icon turns green
This causes both LEDs to be switched on (flashing) for all EasyF-xxx modules in the EasyBus sub-
net.
This function is extremely useful for finding or visually identifying a specific EasyBus subnetwork in
a building.
To deactivate this functionality, click on the green icon again.
Clicking on "Add Modify Slave"
The system allows you to open the Master Wizard to perform a new scan or to change the
channel currently in use. For more information, see chapter 4.1 Start-up and channel assignment
Construction subject to change
No return possible
EasyBus
User manual EasyS-H01
Version: 2023-01-11 | Page 31