DAN DRYER ELITE 2000 HAIR DRYER CLASSIC & SHAVER Manual

PRODUCT OVERVIEW

Enclosed with the hair dryer are the installation instructions as well as a small plastic bag containing:
2 pcs. screws
2 pcs. rawlplugs
2 pcs. washers
1 pcs. plastic cap
1 pcs. wall mounting bracket

PRIOR TO INSTALLATION

Before installing the hair dryer, please check that the power supply has sufficient capacity to handle the extra wattage specified on top of the dryer housing.

Be sure to install the unit right next to a mirror, if any, thus preventing users from stretching the flexible hose to the breaking point in the attempt to look at themselves in the mirror.

The hair dryer is double-insulated and thus needs no earth connection.

FIXED WALL MOUNTING

1. Disassemble cover plate by removing the in Fig. 1 with A marked screw. Attach unit to the wall, using the two holes marked with screws and rawlplugs.
   
2. Mark and drill two 6 mm holes in the wall, vertically underneath each other and 198 mm apart (Fig. 2). Recommended installation height from the floor to the top edge of the dryer is 180 cm.
   
3. Feed supply cable through the cable inlet hole at the top right corner and connect to terminal block. Attach dryer housing using the screws and washers enclosed (Fig. 3).
   

The ELITE hair dryer complies with the EU directive 87/308 on the reduction of electromagnetic interference.

USER INSTRUCTIONS

• Activate hair dryer by removing the handle. The Elite 2000 offers three-step adjustable air volume and temperature setting.
• Avoid directing the airflow towards your eyes.
• Do not obstruct free airflow.
• Keep the dryer at an adequate distance from your hair.
• Always replace handle onto housing after use.

MAINTENANCE

• Clean plastic parts with a cloth wrung in soapy water.
• Do not use corrosive cleaning products.

VARIANT OF THE DAN DRYER ELITE 200 CLASSIC

• Model SHAVER is equipped with a 115-230 V shaver plug for electric razors – and razors only!

This product is covered by the WEEE regulations on the recycling and recovery of waste electrical and electronic equipment.

• This product is not to be treated as household refuse.
• This product must be recycled if possible.
• Contact local authorities for advice.
• The product may also be returned to the manufacturer/distributor free of charge. The manufacturer/distributor will ensure proper recycling/ disposal.