Popp POPE011801 Quick Start

Hub smart home gateway

Popp

POPP HUB Smart Home Gateway

SKU: POPE011801

Quickstart

This is a

for .

1. Connect the HUB to your local network using Ethernet cable.

2. Power up the controller. After up to 2 minutes the HUB is ready

to use and the white LED will breathe normal. Now you can

connect your computer or mobile device to the new WIFI

Popp-xxxx (xxxx=last 4 digits of MAC address displayed on

device label,

WIFI-password on label too). Attention: For security reasons the

initial configuration is available via WIFI only. Later on you

have more options.

3. Point your browser to http://192.168.1.1. If you use a mobile

device install and start the Popp HUB app (Use the QR code

on page 4).

4. The welcome screen displays your unique device ID.

Remember it for remote access! Define your access password

for the default login name 'admin' and your email for password

recovery.

5. In case there is a firmware update you will see a message

screen. Please confirm and update the firmware. Make sure

not to un-power the device during the firmware update.

6. Now you can access your controller from outside your home

too using the service find.popp.eu. Use DEVICE_ID/LOGIN

(e.g. 12345/admin) and your password.

Table of Contents

Need help?

Do you have a question about the POPE011801 and is the answer not in the manual?

Page 1 WIFI only. Later on you have more options. 3. Point your browser to http://192.168.1.1. If you use a mobile device install and start the Popp HUB app (Use the QR code on page 4). 4. The welcome screen displays your unique device ID.
Page 2 The POPP HUB is focused on easy operation and reliable security architecture. Therewith it is one of the most secure smart home gateways generally. Thanks to the integrated device database and step-by-step instructions any new smart home device can be connected quick and easy.
Page 3 Inclusion/Exclusion On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion. Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network.
Page 4 Wakeup Notification — is a special wireless message issued by a Z-Wave device to announces that is able to communicate. • Node Information Frame — is a special wireless message issued by a Z-Wave device to announce its capabilities and functions. •...