Bosch 0 601 9F0 001 Original Instructions Manual page 7

(3) Gear selector switch
(4) Carrying strap lug
(5) Battery release button
(6) Battery
(7) Rotational direction switch
(8) On/off switch
(9) "PowerLight" lamp
(10) Handle (insulated gripping surface)
Cordless Impact Wrench
Article number
Rated voltage
A)
No-load speed
– Setting 1
– Setting 2
A)
Impact rate
– Setting 1
– Setting 2
A)
Max. torque , hard screwdriving application
according to ISO 5393
Machine screw diameter
Max. screw diameter
Tool holder
Weight according to EPTA-Procedure
01:2014
Recommended ambient temperature during
charging
Permitted ambient temperature during opera-
B)
tion and during storage
Recommended rechargeable batteries
Recommended chargers
A) Measured at 20–25 °C with rechargeable battery GBA 12V 1.5 Ah.
B) Limited performance at temperatures < 0 °C
Assembly
Remove the battery from the power tool before carry-
u
ing out work on the power tool (e.g. maintenance,
changing tool, etc.). The battery should also be re-
moved for transport and storage. There is risk of injury
from unintentionally pressing the on/off switch.
Battery Charging
Use only the chargers listed in the technical data. Only
u
these chargers are matched to the lithium-ion battery of
your power tool.
Note: The battery is supplied partially charged. To ensure
full battery capacity, fully charge the battery in the charger
before using your power tool for the first time.
Bosch Power Tools
a)
(11) Double bit
(12) Universal bit holder
a)
(13) Screwdriver bit
(14) Application tool (e.g. impact socket)
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
Technical data
GDR 120-LI
3 601 JF0 0..
V=
-1
min 0–1300
-1
min 0–2600
-1
min 0–1900
-1
min 0–3200
Nm 100
mm M4–M12
mm
¼" internal hexagon
kg
°C 0 to +35
°C –20 to +50
GBA 12V ...
GAL 12 ...
GAX 18 ...
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging process
does not damage the battery.
The lithium-ion battery is protected against deep discharge
by the "Electronic Cell Protection (ECP)". When the battery
is discharged, the power tool is switched off by means of a
protective circuit: The application tool no longer rotates.
Do not continue to press the On/Off switch after the
u
power tool has automatically switched off. The battery
can be damaged.
Removing the battery (see figure A)
To remove the battery (6), press the release button (5) and
pull the battery downwards out of the power tool. Do not
use force to do this.
English | 7
a)
a)
GDS 120-LI
3 601 JF0 1..
12 12
0–1300
0–2600
0–1900
0–3200
105
M4–M12
8
∎ 3/8"
1.1 1.1
0 to +35
–20 to +50
GBA 12V ...
GAL 12 ...
GAX 18 ...
1 609 92A 70Y | (22.03.2023)
8