Table of Contents
Advertisement
en Before using for the first time
7 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
7.1 Initial configuration
When the appliance is connected to the electricity sup-
ply for the first time or following a lengthy power cut,
you need to configure the settings before you can use
it. It may take a few seconds for the settings to appear
in the display.
Turn the control ring to change the setting as re-
1.
quired.
Possible settings:
– Language
– Clock
Press
to confirm.
2.
a The next setting appears.
Work through the settings and make changes as re-
3.
quired.
a After the last setting, a note appears in the display
confirming that the initial configuration is complete.
a The time that is set appears on the display.
To check the appliance before heating for the first
4.
time, open and close the appliance door once.
8 Basic operation
8.1 Switching on the appliance
Press
to switch the appliance on.
▶
a The Bosch logo appears in the display. The types of
heating then appear.
8.2 Switching off the appliance
Switch your appliance off when you are not using it.
The appliance will switch itself off automatically if it is
not used for a certain period of time.
Press
to switch the appliance off.
▶
a The appliance switches off. Any functions currently
in progress are cancelled.
a The time or residual heat indicator appears in the
display.
8.3 Starting operation
You must start each operation.
Press to start.
▶
a The settings, the running time, the display ring and
the heating line appear in the display.
10
7.2 Cleaning the appliance before using it
for the first time
Clean the cooking compartment and accessories be-
fore using the appliance to prepare food for the first
time.
Remove the product information and the accessor-
1.
ies from the cooking compartment. Remove any
leftover packaging, such as polystyrene pellets, and
the adhesive tape that is in or on the appliance.
Wipe the smooth surfaces in the cooking compart-
2.
ment with a soft, damp cloth.
Press
to switch the appliance on.
3.
Apply the following settings:
4.
Type of heating
Temperature
Cooking time
→ "Basic operation", Page 10
Press to start.
5.
Keep the kitchen ventilated while the appliance is
‒
heating.
a Once the time has elapsed, an audible signal
sounds and the display shows the time as zero.
Press
to switch the appliance off.
6.
Once the appliance has cooled down, clean the
7.
smooth surfaces in the cooking compartment with
soapy water and a dish cloth.
Clean the accessories thoroughly using soapy water
8.
and a dish cloth or soft brush.
8.4 Pausing or cancelling operation
You can briefly pause operation and then continue. If
you cancel operation completely, the settings will be re-
set.
To pause operation briefly:
1.
Briefly press .
‒
To continue operation, press .
‒
To cancel operation completely, press and hold
2.
for approx. 3 seconds.
a Operation will stop and all the settings will be reset.
8.5 Setting the type of heating and
temperature
Requirement: The operating mode "Types of
heating" has been selected.
Use the control ring to set the required type of heat-
1.
ing.
Press
.
2.
a The temperature is highlighted in white.
Use the control ring to set the temperature.
3.
Press to start.
4.
a The appliance starts heating.
a The target temperature, the time and how long the
appliance has already been in operation are shown
in the display.
4D hot air
Maximum
1 hour
Advertisement
Table of Contents
