Advertisement
Product Information
Our full colour video door phone allows you to clearly see who is at the door using inbuilt
wire-free technology. As well as live video, the door phone takes pictures of your last 20
visitors so you know who has called while you were out.
What's included...?
1. Camera Unit
9. Battery Door
2. Camera Sensor
10. Receiver Unit
3. Infrared LED
11. 2.4" TFT LCD Display
4. Indicator LED
12. Indicator Light
5. Speaker
13. Speaker
6. Microphone
14. Power Button
7. Call button
15. Menu Button
8.Sync (Pairing) Button
16. Talk Button
Battery Installation
1. To open the battery compartment, turn knob located on the battery compartment door
counter-clockwise.
2. Insert 4 x AA Batteries (Alkaline recommended)
3. Replace battery door, turn the know clockwise to close. Keep turning until tight.
www.lifemaxuk.co.uk
Document Version No
1271IM13102022.indd 3-4
1271IM13102022.indd 3-4
Initial Setup
NOTE: Your Video Door Phone should be paired, ready for use. If it doesn't work straight out
of the box you may need to complete the below pairing procedure.
Receiver Unit: Press the Power Button first, then press Menu Button for 5 seconds until
the green LED starts to flash.
Camera Unit: Press and hold Sync Button then press the Call Button (keeping the Sync
button held in). The screen on the receiver will active to indicate that paring is complete.
How to Use
1. When someone presses the Call Button on the Camera Unit, the Receiver unit will play a
door chime and the video will come on.
2. Home owner must press the Talk Button on the Receiver Unit to talk back to the visitor.
When done speaking, home owner must release the Talk Button to let the visitor answer.
Video Memory Visitor Log
1. Home owner has the ability to go back and check the video visitor log.
2. Press the Menu Button once and then press UP or DOWN key to review the visitor log.
The camera will take a picture of each visitor and these are stored on the receiver unit.
The maximum capacity is 31 pictures. The first picture will be image No 1, the second will
be image No 2 and so on up to 31. After 31 pictures, the first picture will be deleted and
replaced automatically by each new picture. The last visitor will always be image No 31.
17. Lithium Polymer
To delete a picture, when reviewing the visitor log, short press " " or " " button to display
Battery
(built-in)
the pictures then hold the "-" button. Select "Yes" by short pressing the menu button to
18. AC Adapter
delete or press "+" button to select "No" followed by short pressing the "Menu" button to
19. Double Sided
cancel deletion of the photos.
Adhesive Foam
To adjust the picture quality, press the UP or DOWN key when in Call Mode.
20. Metal Wall Bracket
Press the +/- buttons to adjust the sound level.
21. Screws
Camera Installation
22. Charging Dock
NOTE: The camera unit is water resistant but exposure to extreme weather can cause
irreparable damage to this device. Where possible, the camera unit should be mounted in a
sheltered area. You have two options for mounting the camera:
Using Screws (for cement/brick walls):
First, mount the Metal Bracket onto a wall or door using the provided fixings. Next, attached
the Camera Unit to the bracket. See fig. 1 for reference.
Document Version No
www.lifemaxuk.co.uk
Continued overleaf
13/10/2022 16:02:41
13/10/2022 16:02:41
Advertisement
