Summary of Contents for AIMobile NC-X1
- Page 1 NC-X1 Image Refresh User Manual 9 December 2022 Version 1.3 Page 1 of 7 Copyright protected. All rights reserved.
- Page 2 Content Introduction ............................1 Board Overview ............................ 1 Getting Started ............................2 3.1. Hardware Requirement ......................2 3.2. Download Image & Refresh Script ..................2 3.3. Image Refresh Procedures ...................... 2 3.4. Enter Force USB Recovery Mode ................... 3 Trouble Shooting ..........................4 4.1.
- Page 3 Revision History Date Version Modification 2021/06/16 Creation 2022/11/10 Modify to fit Jetpack 5.0.2 2022/12/8 Change binary image compress file name 2022/12/9 1. Correct burning script name 2. Add lz4c error trouble shooting Page 3 of 7 Copyright protected. All rights reserved.
- Page 4 1. Introduction This document is to describe how to download Jetpack 5.0.2 system image to NC_X1 device, including hardware requirement, download environment & image preparation and download procedures. 2. Board Overview Page 1 of 7 Copyright protected. All rights reserved.
- Page 5 2. USB Type-A to Micro USB cable (to connect Host PC/NB to NC_X1) 3.2. Download Image & Refresh Script 1. Check the OneDrive URL provided by AIMobile for image refresh package (X1_r35_1_0.tar.xz in the example below). 2. Download the image refresh package and extract it to Linux Host PC/NB, a...
- Page 6 3.4. Enter Force USB Recovery Mode To update your device, you must be in Force USB Recovery Mode so that you can transfer system image to the Jetson Xavier NX device. To place device in Force USB Recovery Mode, 1. Power down the device. If connected, remove the DC power from the device. The device must be powered OFF, and not in a suspend or sleep state.
- Page 7 4. Trouble Shooting 4.1. lz4c error The image refresh progress will utilize lz4c tool, if the Linux host PC doesn’t have this tool installed, you may meet the error message as the image below. If so, please use the command sudo apt-get install liblz4-tool to install the lz4c tool to solve it.
Need help?
Do you have a question about the NC-X1 and is the answer not in the manual?
Questions and answers