Table of Contents
Advertisement
BEFORE FIRST USE
1.
Remove all packaging including the interior packaging around the chimney
inside the chaff collector.
2.
Go to the Nucleus website and activate your warranty.
3.
Please read 'The basics' section below and familiarize yourself with the
'Safety' section above.
4.
Download the Nucleus Link pro logging software to your computer desktop.
5.
Download the Link Profile selector app.
TESTING
The correct way to test the roaster is to start it with no beans. It will heat up for 10
to 20 seconds, reaching about 90 degrees.
Then a message will flash up: "Heat too fast. Please check beans." At this point,
the machine doesn't stop, but it begins the cool-down cycle and runs for another
10 to 20 seconds until it has cooled down to about 40 degrees. At this point, it
stops.
Running this test is a good way to be confident that everything is working as
expected. This test will also generate a log file so it can be used to check you have
set things up correctly for collecting roast logs.
Note: that at each 150 run motor hours unit is taken to your countries service
partner for a preventive Maintenance.
At 250 run motor hours, preventive maintenance has yet to be undertaken your
unit will notify you that this servicing is a must.
Failure to adhere to servicing requirements may void remaining the warranty on
your unit.
10
THE BASICS
STEP 1
Place the density tube on a scale and tare
the scale. Use a level dose of coffee into the
density tube and make note of the weight of
the beans.
STEP 2
Enter the weight of your coffee into the
Nucleus Density App and recieve a profile
and select the Processing and Varietial of the
Green coffee you are using.
STEP 3
Remove the chaff collector and load 100g of
the same green coffee into the roaster.
11
Advertisement
Table of Contents
