Getting Started; Brightness Adjustment; Playing Music - Bresser BCC1001 Operating Instructions Manual

GETTING STARTED

Power supply
1. Insert the Micro USB Charging cable (included) to the
DC 5V input port located at the rear of the unit. Insert
the other end into a suitably rated wall outlet.
2. Push the Power switch to the ON position to turn on
the device. The time will be displayed.
3. Press and hold the [
status.
NOTE: To turn off the device and the screen, push the
Power switch to OFF position.
Internal battery
The speaker contains 2 sets of 2200mAh batteries
in the speaker. When fully charged, the speaker
can operate without a power supply and become
portable.
NOTE: The charging time is around 3 hours.
Wireless charging
1. Stellen Sie das Gerät, das Sie laden möchten auf den
Kreis oben auf dem Lautsprecher.
2. Das Gerät wird nun geladen.
HINWEIS: Ihr Gerät muss kabelloses Laden
unterstützen.
USB charging
1. To charge a device, connect with a USB charging
cable to this USB charging port [
2. Device will now start charging.
NOTE: When using the wireless charging and USB
charging at the same time, USB charging would be
disabled for the purpose of keeping the maximum
output capacity within safe level.

PLAYING MUSIC

Pairing/Disconnecting
via Bluetooth
1. Place your device nearby. Press the [
the [ ] flashes.
2. Search for Bluetooth according to your device's
instructions.
3. The speaker is named "ES BCC1001", enter the PIN
"0000" if needed.
] to enter or exit standby
] at the rear.
] till
4. The speaker will beep when complete pairing.
The [ ] stays on.
NOTE: To disconnect the Bluetooth, press and hold
[ ].
AUX
1. Plug the 3.5mm audio cable (not included) into
audio input connector and automatically switch
switch from Bluetooth mode to AUX mode. To switch
the mode manually, press [
AUX and Bluetooth mode.
2. Unplug the 3.5mm audio cable from AUX and the
speaker returns to Bluetooth status automatically.

BRIGHTNESS ADJUSTMENT

1. Press [ ] once, all icons will flash.
2. To set the brightness of display, short press [ ] or [ ].
3. Wait for 3 seconds. The brightness you set would be
saved automatically and exit brightness setting.
CLOCK
Set clock automatically
The time is set automatically by the Bluetooth connection
of an iPhone.
NOTE: Not applicable to Android Smartphones.
Set clock manually
4. Press [ ] twice to enter time setting mode.
5. The setting parameter will flash.
6. Press and hold [ ] button to confirm setting and
enter to next parameter.
7. Press [ ] oder [ ] to set the required data.
8. Sequence of setting: Hour -> Minute -> 24Hr/12Hr
9. If there is no action in 3 seconds, the setting will be
saved and will exit the setting mode.
ALARM
Set alarm time
1. Press [ ] triple to enter alarm 1 setting mode. The
[ ] will be on. (Press four times to enter alarm 2
setting mode. The [ ] will be on.)
2. The setting param eter will flash.
3. Press and hold [ ] button to confirm setting and
enter to next parameter.
4. Press [ ] or [ ] to set the required data.
5. Settings order: Hour -> Minute -> Alarm OFF/ON
GB
] to switch between
13