Using Additional Handsets; Register An Additional Handset - LiGo BT 4000 Setup & User Manual

Using additional handsets

50
You can register up to five GAP
compliant handsets to your
BT4000 base to extend your
phone system without needing
to install telephone extension
sockets for each new phone.
If a handset becomes
un-registered it will need to be
registered to the base again.
Please register this handset will
be displayed, select
follow the instructions starting
from point 4 below.
You have 2 minutes to complete
the registration process. After 2
minutes the In use light on the
base will stop flashing.
If registration isn't successful
the first time, please try again
incase the base registration
period ran out of time.
If there are already five
handsets registered to the
base, the registration will fail.
You must de-register another
handset before you can register
the new one.
1662 BT4000 UG [3].indd 50
If you've bought a BT4000 multiple pack, any
additional handsets come pre-registered to the
base. However, if you purchase an additional
handset separately, you must register it to your
BT4000 base before it can be used.

Register an additional handset

1. Select
press
then
OK
2. Press
3.
Register handset
4.
Press & hold 'Find Phone' on base
5. Press and hold
beep and the In use light starts to flash.
6. The handset will display
to indicate the base is in registration mode. If the
system PIN is not 0000 then you will be prompted
to enter it, then select
7. Once registration is successful the handset will show
Handset x
handset number). The handset will then synchronise
data with any other registered handsets, e.g. contacts,
speed dials and handset names.
If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
, scroll to display
Menu
.
OK
to display
Registration
is displayed, press
on the base until you hear a
Registering handset...
.
OK
registered (with X being the assigned
and
Settings
and press .
OK
.
OK
is displayed.
09/04/2013 15:03