AMT Little Loudmouth LLM-1 Quick Start Manual

Guitar and bass guitar volume
pedalAMT "Little Loudmouth" LLM-1
Safety instructions
WARNING! Inside the device there are no parts that are user-serviceable. Repairs
to the machine may only be performed by qualified personnel.
WARNING! To avoid failure, the device should not be exposed to rain or moisture
inside the device must not be exposed to water or other liquid. Do not place near
filled with liquids, such as vases, etc.
Внимательно ознакомьтесь с инструкцией по эксплуатации.
1. Keep the manual.
2. Heed all warnings.
3. Follow all instructions.
4. To clean the unit, use a dry cloth, first unplug the appliance
and unplug it from the power adapter.
5. Do not install near any heat sources or expose to direct
sunlight.
6. Place the power cord so that it can not be stepped on, and
avoid its contact with sharp corners, etc. In that case, if the
plug or socket adapter is used to disconnect the unit from the
network, they must be easily accessible.
7. Only use attachments and accessories recommended by
manufacturer.
8. Unplug the AC adapter (when using the AC adapter) during a
thunderstorm.
9. When not in use for a long time, remove the battery from the
device case.
10. All work associated with the repair of the device must be
performed by qualified service personnel.
11. WARNING! These service instructions are for use by qualified
personnel. Do not carry out any repair work not described in
the instruction manual. Repairs must be performed by qualified
.
personnel
www.amtelectronics.com
1
IMPORTANT NOTICE!
Violation following instructions can cause damage to your DEVICE. DAMAGE
ARISING will void your warranty
When transporting or storing the product in the freezing

temperatures, before turning on leave the device at room
temperature in its original packaging within 2 hours, no
less!
To connect the preamp to other devices, use only the

cables intended for such connections.
Do not use other cables, such as acoustic, etc.

Before you start
To ensure the safe transportation of the device was carefully packed at the
factory. However, if the box is damaged inspect the unit immediately for signs
of damage.
If you see damage do not sent directly to the address of

the manufacturer, but notify your dealer and the shipping
company, otherwise
compensation.
Only use attachments and accessories recommended by
manufacturer.
Connecting the AMT LLM-1 to the power adapter
The connection is made

connections!
Before connecting the AMT LLM-1 to the power adapter,

make sure that the case, connection cable, and plug the
AC adapter are not damaged: no cuts, cracks, dents, etc.
and are in good condition.
To connect the AMT LLM-1 to the AC adapter, insert the

low-voltage connector adapter into the jack on the right
panel of the preamp, and then plug the adapter into the
wall outlet.
Disconnecting the preamp from the power adapter
To disconnect the AMT LLM-1 from the AC adapter,

disconnect the AC adapter from the power outlet, and then
disconnect the low-voltage connector from the socket on
the right-hand panel of the AMT LLM-1.
To prevent damage during storage and transport use the

original packaging.
Do not let children play with the packaging.

Please dispose of all

environmentally friendly way.
To avoid overheating of the device is provided with

sufficient ventilation, do not cover it, and do not place near
heating radiators etc.
Operation near powerful radio transmitters and high-

frequency sources can lead to a marked deterioration in
sound quality. In this case, increase the distance between
the sensor and the transmitter and use shielded cables for
all connections.
WARNING!
Please note that high volume can damage your hearing and / or
damage to the dynamic head of your speaker system. Before
switching on the unit, turn knobs «Volume» to the left (counter
clockwise). Always make sure that volume is moderated.
www.amtelectronics.com
you will lose the right
:
only after all the
:
packaging materials
1
to
audio
in an