Rimage Amigo II Hardware Manual page 2

Replace a Quick-Release Recorder on an Amigo II
Install the Recorder
1. From the front of the system, connect the cables to the replacement recorder.
•
Power cable
•
FireWire cable
Important! Make sure that you tighten the tie wrap to secure the FireWire cable.
2. Insert the recorder into the system until it clicks into place.
Caution! If you feel resistance, make sure that th
straighten the cables, and reinsert the recorder.
3. Close the front door.
4. Connect the power cord to the power outlet.
Tip: You should not need to align the new recorder unless you are experiencing disc picking problems. F
instructions, refer to the Align a Recorder document found
Producer Family > Support – Amigo II > Documents Tab.
Support information
Europe
Contact Rimage Services Eur
www.rimage.com/support.ht ml
Email: support@rimage.de
Tel: +49-(0) 6074-8521-0
US, Asia/Pacific, Mexico/Latin America
Contact Rimage Services:
www.rimage.com/support.html
Email: http://www.rimage.com/supp
Tel: North America: 800-553-8312
Asia/Pacific, Mexico/ Latin America: 952-946-0004
2000765_A
When you contact Rimage Services, please provide:
ope: •
Unit serial number and software version.
•
Functional and technical descrip
•
Exact error message received.
Rimage Corporation reserves the right to make improvements to the
equipment and software described in this document at any time without
any prior notice. Rimage Corporation reserves the right to revise this
publication and to make changes from time to time in the content hereof
ort_form.cfm
without obligation of Rimage Corporation to notify any person or
organization of such revisions or changes.
© 2007, Rimage Corporation
e cables are not being pinched. Pull the recorder out,
at www.rimage.com/support.html. Navigate:
tion of the problem.
Amigo II™
or
2