Advertisement
•
Loosen and remove the height adjustment nut from the top of the inner tube.
•
Place the Base cover onto the pole and replace the height adjustment nut.
•
Then connect the pole assembly to the base with the 'L' shaped screw supplied.
•
Tighten until secure.
•
Slide the Base cover down over the assembly.
This way up
•
Take off guard lock nut from motor housing.
•
Place the rear guard on the front of the motor housing. Line up the lugs on the front of the
motor housing with the holes in the rear guard. Ensure handle is at the top.
•
Screw on guard lock nut tightly to attach rear guard.
•
Place the fan blade on the motor shaft ensuring the small locating grooves on the back of the
blade are pointed to the rear grill so they engage with the pin in the motor shaft. Secure it by
tightening the fan blade nut.
•
Place the front guard and install the plastic ring around the grids.
•
Tighten the screw of the plastic to set in place.
•
Insert inner tube into fan control panel and
secure by tightening the large screw at the rear
Assembly
Advertisement
