Do you have a question about the BU-2000 and is the answer not in the manual?
Questions and answers
Summary of Contents for PumpSpy BU-2000
Page 1
2000W PRIMARY SUMP PUMP BACKUP POWER SYSTEM INSTRUCTION AND OPERATING MANUAL MODEL: BU-2000...
Page 2
GENERAL INFORMATION To ensure safe and reliable operation, please carefully read this service and installation manual in its entirety before installing and/or using this product. Reasonable care and safe methods in according with sound plumbing practices should be strictly adhered to. Before installation, refer to and understand all relevant local plumbing and electrical codes.
Page 3
PERFORMANCE The Primary Sump Pump Backup Power System will convert DC power from a 12VDC Deep Cycle Battery to AC power. When the Primary Sump Pump Backup Power System is inverting, the output waveform is a pure sine wave. SPECIFICATIONS ATTENTION The Primary Sump Pump Backup Power System is grounded via a PCB Ground Plane.
Page 4
The “Fault” status indicator LED will turn RED when the Primary Sump Pump Backup Power System is overloaded, overheating, receiving low household voltage, or has a short circuit. Multiple 12VDC Deep Cycle Batteries may be connected in parallel. A PumpSpy Maintenance Free AGM Deep Cycle Battery is recommended. - 3 -...
Page 5
INSTALLATION 1. Ensure the Backup Power System is powered off and disconnected from both AC and DC power. 2. Remove the Pre-Charge Kit from the positive (RED) battery lead ring. Open the Pre-Charge Kit and wrap one of the resistor wires around the positive (RED) battery lead ring.
Page 6
It is not a service guide. Dismantling of the Primary Sump Pump Backup Power System voids warranty. Servicing of power unit should be referred to PumpSpy. “FAULT” STATUS INDICATOR LED IS RED A RED “Fault”...
Page 7
(the “Warranty Period”). During the warranty period, PumpSpy will repair or replace at no cost to you, to correct such defects in products found upon examination by PumpSpy to be defective in materials or workmanship.
Need help?
Do you have a question about the BU-2000 and is the answer not in the manual?
Questions and answers