spatex E-10 Instruction Manual

E-10 & E-14 Spa Circulation Pump Instruction Manual
Resellers - Please ensure that the pump owner receives a copy of this manual

Warning

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capacities, or lack
of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.

Unpacking

When unpacking the unit, inspect carefully for any damage that may have occurred in transit. Check for loose, damaged or
missing parts. Any problem - contact either the supplier purchased through, or spatex immediately. Do not attempt to repair or
modify in any way or warranty may be void.

Installation

These pumps have been evaluated and authorised for water use only in spa / pool applications.
Ensure the power source is correct: 220v-240v, 50 / 60Hz
Maximum operating head pressure for E-10 & E-14 pumps - 2 bar.
Maximum water temperature - 60 degrees C.
Ensure installation is in a clean, dry, weather & humidity protected location with adequate air ventilation. Ensure the power cord
is run in such a way that any water that may get on it, cannot run down the cord to the motor. This unit cannot be submerged -
ensure it cannot flood.
Protect cords from sharp objects, hot surfaces; avoid kinking or coiling of the cord. Replace damaged cords immediately.
Locate pump as close as possible to the fluid source thus making the suction line as short and direct as possible, using tubing on
the suction that cannot collapse, such as a reinforced type.
Support the tubing independently of the pump. Use clamps to secure and seal the tube to the pump.
These pumps are liquid lubricated. How they are mounted, and water condition/quality are important.
sales@spatex.com.au
www.spatex.com.au
1300 SPATEX
Installation, Operation and Warranty
E-10 circulation pumps
E10-NSHNDNN2W-05
E-14 circulation pumps
E14-NSTNDNN2W-01