Handle Assembly - Hyundai 15EPML Operation Manual

4. Handle assembly

For safe transportation and packaging, handles of the truck have been disassembled
when ex-factory. Therefore, users should assemble handles before use. The assembly
procedures are as follows:
4.1 Refer to drawing 1, disassemble pin 1 from pin 2, and pull out pin2.
4.2 Refer to drawing 2, take down screw 3 & remove cover plate 4 from handle assembly 5.
4.3 Refer to drawings 3 and 4, insert handle assembly 5 to A, connect handle assembly 5
and pump 10 with pin 2, then make chain 8 go through hole of pin 2. Rotate handle 5 to
horizontal position and pull out pin 9, and keep pin 9 well for next use. Connect wiring harness
in handle assembly 5 and wiring harness on truck body by connector 6, and fasten with belt
to ensure reliable connection (refer to drawing 5). After connecting the wiring harness, fix
wiring harness to handle assembly 5 through line card 7.
1 Drawing 2
Drawing
Drawing 3 Drawing 4
5