tekkiwear SC632 User Manual

Electric microcrystallograph

Table of Contents

Download this manual

Electric microcrystallograph – SC632

USER MANUAL

Parts Name

1. Adjustment of speed and ON/OFF; 2. Adjustment of needle length; 3. Needle connect; 4.

Needle catridge

1. Usage method

1) Clean skin: daily make-up removal, cleansing, can use toner for secondary cleaning.

2) Take out the nanowafer and install it on the top of the m i crocrystallizer.

3) Apply proper amount of liquid or essence to your face.

4) Press the power switch key for 3 seconds, start the microcrystallograph, and contact the skin

vertically. Each contact point is recommended to stay for 35 seconds.

Table of Contents

Do you have a question about the SC632 and is the answer not in the manual?

Page 1 Electric microcrystallograph – SC632 USER MANUAL Parts Name 1. Adjustment of speed and ON/OFF; 2. Adjustment of needle length; 3. Needle connect; 4. Needle catridge How to Operate 1. Usage method 1) Clean skin: daily make-up removal, cleansing, can use toner for secondary cleaning.
Page 2 5) After the operation, please turn off the power supply and remove the nano chip, apply the common skin care products, and recommend the use of essence rice. Make a sterile repair mask before applying skin care products. 6) Nano chip can not be used repeatedly, so as to avoid two times of pollution. Instrument operation 1) Long press start/shut down, default first blue light is on, click the button to switch gear cyclically after start, second green light is on, third red light is on.
Page 3 1. Counter clockwise: Lenght of it will be shorter. 2. Clockwise: Lenght of it will be longer. Manipulation techniques Point method: When the microcrystallograph is installed, the nanowafers are vertically touched on the skin surface, and a slight depression can be observed visually, with a gentle and dense upper and lower edge.
Page 4 4) The function of the needle to exert moderate force, not to.press intentionally, nor to lift the wrist intentionally until the wafer can not even touch the skin. 5) About 10-20 minutes after the use of nano-wafers, some people will have skin redness, whichis a normal phenomenon and will disappear within 24 hours without treatment.