Advertisement
Quick Links
Courtyard Vent-Free Conversion Plate
Models:
ODCOUG-VFP
This kit has been tested for use with specific Hearth & Home Technologies products. Check with your local building code
agency before you begin installation to ensure compliance with local codes, including the need for permits and follow-up
inspections. If you encounter any problems regarding code approvals, or if you need clarification of any of the instructions
contained here, contact your Hearth & Home Technologies dealer. For the dealer nearest you, please visit www.hearthn-
home.com.
Model(s)
ODCOUG-36NR
ODCOUG-36TS
ODCOUG-VFP
ODCOUG-42NR
ODCOUG-42TS
This Vent-Free Conversion Plate is designed for use on the
models shown in the chart above. Read these instructions
thoroughly before beginning installation.
ATTENTION!
This kit is designed to convert the Courtyard appliance.
From: CSA/ANSI Z21.97-2017 Outdoor Decorative Gas
Appliance - for outdoor use only.
To: CSA/ANSI Z21.91:20 Ventless Firebox Enclosures for
Gas-Fired unvented Gas Log Type Room Heaters and CSA/
ANSI Z21.11.2:19 Unvented Room Heater, not to exceed
40,000 BTU/HR (11,723 W) – for indoor use only.
CAUTION: Allow appliance to cool completely if it has been
in operation.
NOTE: Gas components are located within the appliance
valve compartment. The Valve Access Cover must be
removed to access components.
KIT CONTENTS:
•
(1) Conversion Plate Assembly
•
(1) Fastener Pack
TOOL REQUIRED:
Phillips head screwdriver
Hearth & Home Technologies • Courtyard Vent-Free Conversion Plate Installation Manual • 4150-960 Rev. A • 02/23
Kit
ACCESSING GAS CONTROL VALVE:
1. Turn off gas supply and allow the unit to cool.
2. Disconnect power at GFCI circuit breaker.
3. Remove logs, grate, and media from the appliance.
4. Use a shop vac or small brush to clean debris left after
removal of logs and media to ensure a clean, flat sur-
face for the Vent-Free Conversion Plate to sit upon.
5. Remove the Valve Access Cover by grasping cover by
the edges, lift and pull forward out of the appliance. Gas
components should now be accessible. See Figure 1.
Appliance
Components
Valve Access Cover
Figure 1
Installation
Instructions
Advertisement
Related Manuals for Outdoor Lifestyles ODCOUG-VFP
Summary of Contents for Outdoor Lifestyles ODCOUG-VFP
- Page 1 Courtyard Vent-Free Conversion Plate Models: ODCOUG-VFP This kit has been tested for use with specific Hearth & Home Technologies products. Check with your local building code agency before you begin installation to ensure compliance with local codes, including the need for permits and follow-up inspections.
- Page 2 6. Remove Rear Cover by removing (3) screws securing 11. Install Vent-Free Conversion Plate, covering the hole cover to burner assembly. Lift Rear Cover and Pilot in the firebox bottom, where the burner assembly was Shield straight up and set aside. See Figure 2. removed.
Need help?
Do you have a question about the ODCOUG-VFP and is the answer not in the manual?
Questions and answers