Operation; Cleaning, Care And Maintenance; Troubleshooting - Buffalo FA118 Instruction Manual

Operation

Air pipe slot
Air pipe
On/off switch
Automatic overheating protection
This appliance features automatic overheating protection. Should the appliance overheat, the appliance
will shut off automatically. Please allow 20 minutes for the appliance to cool down before resuming
operation.
Cleaning, Care & Maintenance
Switch off and disconnect the appliance from the power supply. Allow to cool down
•
before cleaning.
• Clean the external surface daily using a damp cloth. Always wipe dry after cleaning.
• When closing for the day, operate the appliance for 20 minutes to dry the brushes. This will also
ensure efficiency for next working cycle.
• If maintained, the brushes will provide consistent results. Please periodically check the brushes for
wear and aging, and replace as necessary. Worn brushes will provide variable results.

Troubleshooting

A qualified technician must carry out repairs if required.
Fault
The unit is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Loud noise in use Brushes not installed in place
Brushes spin too Odds and ends may get jammed
slowly inside the brushes
FA118_ML_A5_v3_20230627.indb 5 FA118_ML_A5_v3_20230627.indb 5
Rotating shaft
Handle
Probable Cause
1. Connect the appliance to the
mains power supply.
2. Switch the appliance on
(I position).
Brush
3. Hold the glass by the base
and place over the centre
brush to start drying and
polishing.
4. For better polishing effect,
you can slightly spin the glass
left or right while holding it.
5. After use, ensure that the
appliance is switched off
(O position).
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Install brushes well
Check and remove the jammed bits
EN
5
2023/6/27 15:14:40 2023/6/27 15:14:40