Advertisement
Instruction Manual >
7.
Fully tighten the (4) 1/4"-20 buttonhead bolts (Steps 5 & 6) and the two stock allen bolts (Step 6).
8.
Attach the hose and hose clamp that was disconnected in Step 2 to the tube on the mounting plate.
9.
Insert the round intake screen into the black ring so the screen sits inside the edge of the ring. Place the ring and
screen between the legs of the naked black intake cover as shown in Figure 5.
10.
Place the naked intake cover, ring and screen assembled in Step 9, over the air filter and align each leg to
the base mounting plate threaded holes. Be sure screen sits at a 45 ° angle to the bottom leg, and C/V
logo'd leg is at the upper left position. Insert the (3) supplied 1/4"-20 x 1/2" buttonhead bolts through the
intake cover and into the base mounting plate, see Figure 5. Double check all parts are aligned properly
and tightened securely.
(4) 1/4"-20 X 1/2" BUTTONHEAD BOLTS
& INTERNAL TOOTH LOCK WASHERS
MOUNTING
PLATE
CLEANING INSTRUCTIONS:
To clean your black air intake system use a liquid
based soap detergent, such as dishwashing soap
applied with a soft cloth and rinse with clean water.
Note: Avoid abrasive cleaning methods such as
granular or dry cleansers, simple green, Scotch-Brite
or steel wool pads.
Abrasives may breach the
coating and shorten life.
C / V LOGO'D LEG
POSITIONED HERE
(3) ¼"-20 X 1/2"
BUTTONHEAD
BOLTS
FIGURE 5
IMPORTANT:
Cobra highly recommends using a Fi2000® Fuel Management System to help eliminate lean conditions and possible popping
sounds. (Cobra Part# 92-1775AT & 92-1775CL for 49 state models and Part# 92-1775CL-50 for CA state models.)
DOCUMENT NO. 0018
REV. A
01/14
23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180, Fax. 714.692.5016
®
VELOCITY
INSTALLED
FIGURE 3
INTAKE COVER
(NOTE: DESIGN WILL
VARY BASED ON
PART NUMBER)
06-0225-01B / 02B / 03B / 04B
STACK
(2) STOCK
SUPPORT
ALLEN BOLTS
BRACKET
INTAKE SCREEN
INTAKE RING
In California, aftermarket parts that have been identified specifically
as replacement parts or that have received an Air Resources
Board Executive Order may be used on street motorcycles.
All other emissions related aftermarket parts are for competition
use only. A list of replacement parts and EO parts, and
corresponding fitment is provided at: www.cobrausa.com
2
FIGURE 4
MOUNTING PLATE
ASSEMBLY
K&N
VENTURI AIR FILTER
®
CALIFORNIA CUSTOMERS:
www.cobrausa.com
Page 2 of 2
SUPPORT
BRACKET
INSTALLED
®
Advertisement
