Table of Contents
Advertisement
8-4. Wi-Fi INTERFACE SETTING UP (MSZ-EF·VGKW/B/S)
This Wi-Fi interface communicates the status information
and controls the commands from the MELCloud by connecting
to an indoor unit.
Wi-Fi interface introduction
No.
Item
1
MODE switch
It selects modes.
2
RESET switch
It resets the system and ALL settings.
3
ERR LED (Orange)
It shows the network error state.
4
NET LED (Green)
It shows the network state.
5
MODE LED (Orange) It shows the Access point mode state.
6
UNIT LED (Green)
It shows the indoor unit state.
3
4
5
ERR
NET
6
MODE
UNIT
RESET
MODE
2
1
(1) MODE switch
• The MODE switch is used for selecting modes in configurations.
(2) RESET switch
• Hold down the RESET switch for 2 seconds to reboot the system.
• Hold down the RESET switch for 14 seconds to initialize
the Wi-Fi interface tothe factory default.
NOTE:
When the Wi-Fi interface is reset to the factory default, ALL the configuration
information will be lost. Take great care in implementing this operation.
OBH831C
Front panel
Wi-Fi interface
Front panel
Wi-Fi interface
Description
Wi-Fi
INTERFACE
MODEL
XXXXXXXX
MAC
: XXXXXXXXXXXX
ID
: XXXXXXXXXX
SSID
: XXXXXXXXXXXX
KEY
: XXXXXXXXXXXX
VOLTAGE
:
:
CURRENT
MITSUBISHI ELECTRIC CORPRATION
>PP<
WiFi.ASSY DWG No.
XXXXXXXXXXX
MADE IN CHINA
XXXXXXXXXX
(1) Open the front panel and remove the Wi-Fi interface.
(2) Set up a connection between the Wi-Fi interface and the router.
Refer to the SETUP MANUAL and SETUP QUICK
REFERENCE GUIDE provided with the unit.
For SETUP MANUAL, please go to the website below.
https://www.melcloud.com/Support
(3) Put the Wi-Fi interface back and close the front panel
after the setup is completed.
(4) For MELCloud User Manual, please go to the website below.
https://www.melcloud.com/Support
NOTE:
• Ensure that the Router supports the WPA2-AES encryption setting
before starting the Wi-Fi interface setup.
• The End user should read and accept the terms and conditions of
the Wi-Fi service before using this Wi-Fi interface.
• To complete connection of this Wi-Fi interface to the Wi-Fi service,
the Router may be required.
• This Wi-Fi interface will not commence transmission of any operational
data from the system until the End user registers and accepts
the terms and conditions of the Wi-Fi service.
• This Wi-Fi interface should not be installed and connected to any
Mitsubishi Electric system which is to provide application critical
cooling or heating.
• At the time of relocation or disposal, reset the Wi-Fi interface to
the factory default.
Mitsubishi Electric's Wi-Fi interface is designed for communication to Mit-
subishi Electric's MELCloud Wi-Fi service.
Third party Wi-Fi interfaces cannot be connected to MELCloud.
Mitsubishi Electric is not responsible for any (i) under performance of a sys-
tem or any product; (ii) system or product fault; or (iii) loss or damage to any
system or product; which is caused by or arises from connection to and/or
use of any third party Wi-Fi interface or any third party Wi-Fi service with
Mitsubishi Electric equipment.
For the latest information regarding MELCloud from Mitsubishi Electric
Corporation, please visit www.MELCloud.com.
18
Advertisement
Table of Contents
