General Installation - U-Line U-29R Quick Start Manual

USER GUIDE QUICK START GUIDE
Remove bottom hinge:
1. Remove bottom hinge from cabinet using a 1/4"
socket.
2. Remove corresponding screws on opposite side of
cabinet. On some models there may be a nut behind
one or both screws on either side.
Install bottom hinge:
Install two or three screws, depending on model. Replace
nuts if used.
Install top hinge and door:
1. Rotate door 180 and lift the door on to the bottom
o
hinge.
2. Install hinge that was used on the opposite side of the
unit.
3. Align edge of the hinge with the outer edge of the unit
while inserting hinge pin into top of door.
4. Tighten three screws.
Align and adjust the door:
Align and adjust the door (see DOOR ALIGNMENT AND
ADJUSTMENT)
Install grille
Door Adjustments
USER GUIDE
Door Swing
2-1/8" Min.
90°
Door Swing
Units have a zero clearance for the door to open 90°,
when installed adjacent to cabinets.
Stainless Steel models require 2-1/8" (54 mm) door
clearance to accommodate the handle if installed next to a
USER GUIDE
wall.

General Installation

LEVELING INFORMATION
NOTICE
NOTICE
Because these units do not have leveling legs,
it is extremely important that they sit on a level
surface. If they are not level, the ice mold will not
fill evenly.
Use a level to
confirm the unit is
level. Level should
be placed along top
edge and side edge
as shown.
1
8
Door Swing
Wall
(54 mm)