Chicago Pneumatic CP FL 0022 Safety And Operating Instructions Manual page 14

Safety and operating instructions
Insertion tool
CAUTION Hot insertion tool
The tip of the insertion tool can become hot and
sharp when used. Touching it can lead to burns and
cuts.
Never touch a hot or sharp insertion tool.
►
Wait until the insertion tool has cooled down
►
before carrying out maintenance work.
NOTICE Never cool a hot insertion tool in water,
it can result in brittleness and early failure.
Selecting the right insertion tool
Selecting the right insertion tool is a precondition
for proper machine function. It is important to select
insertion tools of high quality to avoid unnecessary
machine damage.
The machine can be destroyed if you use an incorrect
insertion tool.
Recommended insertion tools are listed in the
machine's spare parts list.
Narrow chisel
Moil point
Clay spade
WARNING Vibration hazard
Using inserted tools that do not fulfil the criterias
mentioned below, will result in a longer time to
complete a task, and may result in higher levels of
vibration exposure. A worn tool will also cause
increased working time.
Make sure that the inserted tool is
►
well-maintained, not worn out and of the proper
size.
Always use a sharp tool in order to work
►
efficiently.
14
The narrow chisel is used for
demolition and cutting work in
concrete and other types of
hard materials.
The moil point is only used for
making holes in concrete and
other types of hard materials.
The clay spade is used in soft
material such as clay.
CP FL 0022, CP FL 0022 S
Fitting and removing the insertion tool
Whenever fitting or removing the insertion tool the
following instructions must be observed:
♦ To prevent an accidental start: switch off the air
supply and bleed the machine by pressing the
start and stop device. Disconnect the machine
from the power source.
♦ Before inserting a tool, lubricate the tool shank
with grease.
♦ Close the tool retainer and check the lock function
by tugging the inserted tool sharply outwards.
CP FL 0022
1. Slide the tool retainer over the shank of the
spade.
2. Place the retainer ring (D) over the stem.
3. Place the split collar (C) over the stem of the
spade, with the small end towards the blade.
Lock the split collar together with the retainer
ring (D).
4. Place the rubber buffer (B) on the shank, forcing
it over the collar by inserting a screwdriver and
rolling it over the collar.
5. If the leather buffer (A) has not been split, make
one cut from bore to periphery. Place it on the
stem, between the collar and the rubber buffer.
9800 0836 90a | Original instructions