Important information Introduction This guide contains an explanation of how to install, commission and main- tain your Raymarine SR100 Sirius Weather System for use with your E- Series display. Intended use This product is a weather information system consisting of a receiver and antenna.
Warranty To register your new Raymarine product, please take a few minutes to fill out the warranty card. It is important that you complete the owner infor- mation and return the card to us to receive full warranty benefits. Your product can also be registered via our website www.raymarine.com...
Suppression Ferrites D6626-1 Connections to other equipment If your Raymarine equipment is to be connected to other equipment using a cable not supplied by Raymarine, a suppression ferrite MUST always be attached to the cable near to the Raymarine unit...
What’s in the box? Weather receiver module What tools do I need? Drill Raymarine SR100 Sirius Weather System - Installation Guide 4.9 ft. (1.5 m) SeaTalk SRA-40 Antenna Mounting gasket 7/64" 9/16" Drill bit Drill bit ethernet cable 25 ft. (7.6 m) Antenna cable 10 ft.
Planning the installation When planning the installation and choosing locations for the antenna and receiver, consider the following points: Receiver Protect from extremes of temperature. DO NOT place near an engine, or where fuel vapor could be present. DO NOT get it wet or put it where it can be splashed with water.
A 10 ft. (3m) power cable is supplied. This cable has a connector plug for connecting to the SR100 weather receiver at one end and three wires at the other for connecting to your boats power supply. This cable may be extended to a distance of 60 ft.
Installing the system The following section gives details of how to install your SR100 Sirius Weather receiver and antenna. Receiver The receiver should be installed a minimum of 3 ft. (1m) away from an engine, compass or any magnetic device.
Page 12
Step 2 Step 3 No.8 x 3/4"screw (x4) Raymarine SR100 Sirius Weather System - Installation Guide Antenna CAUTION: Antenna DO NOT cut the antenna cable or remove the connector. The antenna consists of the following components: Use 7/64" drill bit for...
Page 13
Step 1 Using the gasket as a template mark the center hole and 3 fixing holes. Step 2 Use a 9/16” drill bit to drill the center hole and a 7/64” drill bit to make pilot holes for the fixing screws. Step 3 D9071_1 Fix the mounting gasket and flange into position using the supplied screws.
9 V to 32 V. That is 12 V or 24 V systems. devices D9075_1 There is no power switch on the SR100 receiver, it automatically turns on when the system is powered. AUDIO POWER ANTENNA - for connecting the receiver to your boat’s ethernet...
Page 15
• Floating with neither battery terminal connected to the boat’s ground. It is important that an effective RF ground is connected to your SR100 weather system. You must ground your weather system by connecting the drain wire (screen) of the power cable to the nearest ground point on your boat’s RF...
With the weather system and your E-Series display powered ON: SR100 1. Open a weather application page and make it active. For full details of how to do this, refer to Raymarine Handbook No. Networked Display - Reference Manual 2. Press the MENU key. The Setup dialog box appears.
5. Make a note of your Sirius Weather ID number. 6. Contact Sirius Weather at 1-800-869-5480 to activate your system. Upgrading software There may be occasions when it is necessary to upgrade your Sirius SR100 software. The following section gives details of how to carry out this operation.
Page 18
For full details of how to operate your Sirius Weather Application refer to 81244_2 E-Series Networked Display - Reference Raymarine Handbook No. Manual . A copy of this manual is available from the relevant product pages at www.raymarine.com Raymarine SR100 Sirius Weather System - Installation Guide soft key.The Upgrade soft key.
This section provides information on routine maintenance and trouble- shooting that can be carried out by the user. Your Sirius SR100 Weather System is a sealed unit. DO NOT remove the cover of the receiver. Adjustments require specialized service procedures and tools only available to qualified service technicians.
ON, 2 sec. OFF Blinking It is normal during the first minute of initial power that the SR100 status LED shows no activity and remains off. During the second minute the status LED will start to flash the amber or red fault strings. Typically, during normal operation, a flashing green LED will occur within 90 seconds of initial power.
(603) -881-5200 Help us to help you When requesting service, please quote the following product information: Equipment type Product Repair and Service Raymarine Product Repair Center 21 Manchester Street, Merrimack, NH 03054 - 4801 1-800-539-5539 Opening hours: Monday through Friday 0815 - 1700 Eastern Standard or Eastern Daylight Savings Time.
Page 22
Fuse 2A (recommended) Connectors RJ-45 SeaTalk 3 pin Power 4 pin Audio (not used) SMB RF Antenna Raymarine SR100 Sirius Weather System - Installation Guide Antenna Φ 3½” x 4¼”(including mounting flange and Size gasket) Weight 8 oz. (226 g)
Page 23
Appendix B: List of Abbreviations Abbreviation Description American Wire Gauge CompactFlash Direct current Electromagnetic Compatibility Federal Communications Commission feet International Maritime Organization Light Emitting Diode meters millimeters Degrees Centigrade Radio Frequency Sub Miniature B SOLAS Safety of Life at Sea Universal Serial Bus Volts Very High Frequency...
Page 24
Raymarine SR100 Sirius Weather System - Installation Guide...
‘On Board’ Warranty Service For any Raymarine product or system that (i) has been installed on your vessel by a Raymarine-certified service agent or by a Raymarine OEM, and (ii) has a MSRP equal to or greater than USD $2,500, you are eligible to receive warranty service by a Raymarine certified service agent on-board your vessel (‘On Board Warranty Service’) for a period of...
Page 26
Limitations and Exclusions In addition to any other limitations and exclusions set forth herein, Raymarine is not responsible for, and this Warranty does not cover: • failures due to abuse, misuse, accident, unauthorized alteration or repair, improper installation (whether or not by a Raymarine-certified service agent), shipping damage or corrosion;...
1.2 The Raymarine warranty covers the parts and labour associated with any warranty repair as described above, provided that the product is returned to Raymarine or one of its approved agents. 1.3 Raymarine reserve the right to replace under warranty, not repair, certain Raymarine products subject to the limitations below, provided that they are returned to the nearest Raymarine National Distributor.
Page 28
Subject to the limitations below, the product will be repaired or replaced (at the discretion of Raymarine or a Raymarine Service Agent) at no further cost and promptly returned to the customer. 3.3 In cases where the customer is making a warranty claim and the product has been installed by a Raymarine certified installer, (boat builder, installer, dealer etc.) i.e.
Page 29
Raymarine or a Raymarine service agent be liable for any loss of profit, business, contracts, opportunity, goodwill or other similar loss. The liability of Raymarine or a Raymarine service agent to a customer under this warranty, whether for breach of contract, tort, breach of statutory duty or otherwise, shall not exceed US$1,000,000.