Remove Packaging; Electrical Connection - Rangemaster Ice Maker Operation & Maintenance Instructions Manual

Inspection

Remove Packaging

Your Ice Maker has been packed for shipment with all
parts that could be damaged by movement securely fas-
tened. Before using, be sure all packing materials and
tape have been removed.
Important
Keep your carton packaging until your ice maker has
been thoroughly inspected and found to be in good con-
dition. If there is damage, the packaging will be needed
as proof of damage in transit.
2
How to Install Your Ice Maker
Select Location: The proper location will ensure peak
performance of your appliance. Choose a location
where the unit will be out of direct sunlight and away
from heat sources. Best performance will be main-
tained when installed within the following parameters:
Ideal Ambient Temperature Range
Built-in
Free-Standing
Cabinet Clearance: Ventilation is required from the
bottom front section of the unit. Keep this area open
and clear of any obstructions.
The adjacent cabinets and counter top can be build
around the unit as long as no top trim or counter top
is installed lower than the top of the hinge.

Electrical Connection

WARNING - THIS APPLIANCE MUST BE EARTH-
ED. All external wiring must comply with the IEE
Regulations for the Electrical Equipment of Buildings.
Connections to the electrical supply can be made
with either a plug and socket or be permanently
wired via a double-pole switch.
The appliance is supplied with a 250V PVC(85°C)
core cable (0.5mm²x2.5 metres long). Any replace-
ment cable fitted must follow this specification. The
unit may be supplied with either a moulded or
rewirable plug. Should the plug not fit the socket at
the installation site it should be removed and
replaced with the correct type of plug.
Moulded Plugs: If a moulded plug is fitted which is
not suitable, it must be removed and disposed of. To
avoid the risk of electrocution, a plug must not be left
where a child may plug it into a supply socket. It must
not be used for any other appliance. A three pin plug
to BS 1363 with a capacity of not less than 13A must
be used and fitted with a 13A fuse 'ASTA' approved to
BS 1363.
12° – 27°C
12° – 32°C