Section 4 : Wiring Procedure; Section 5 : Operation; Caution For Wiring; Caution For Operation - Mitsubishi Electric LX-005TD Instruction Manual

4. Wiring procedure

4.1 Caution for wiring

WARNING
Or it may lead to product damage, smoking, firing, or other danger.
4.2 Connection between tension detector and controller.
(1) The drawing shows the connection in the case of tension vector direction applied in the compressive
direction.
When applied in the tensile direction, exchange the wiring of white and green.
(2) When extending the lead wire, use shielded wire.
5. Operation

5.1 Caution for operation

WARNING
During rotation of the detecting roller or other parts, don't touch the tension detector by hand,
finger, or other parts of the body, or you may have electric shock or injury. Protect the exposed
rotating and moving parts with cover to prevent from touching by hand or finger.
During operation of the detector, be careful not to apply large impact load or excessive load. Impact or ex-
cessive load may be caused in the following cases.
1) When the dynamic balance of roller is poor and abnormal vibration is caused due to resonance or
the like.
2) When accelerating or decelerating suddenly in the machine of large bobbin inertia.
3) When a winding shaft torque corresponding to maximum winding diameter is given by mistake in
the case of small winding diameter.
4) When the material has an uneven tension.
Do not drop sawdust or wire chips into product.
Tension detector
Tension detector
Do not touch the product during operation.
( Right )
Green
GRR
White
WHR
S G
Red
RED
Black
BLK
Green
GRL
White
WHL
S G
( Left )
7
Tension control unit
etc.