PARTS
1. On/off switch
2. Pivoting head and cutter assembly
3. Individual flexing heads
4. Hairpocket
5. Turbo button
6. Charging indicator lights
7. Power connector
GETTING STARTED
CHARGING
•
It is recommended to fully charge your appliance before using it for the first time.
•
Ensure the product is switched off.
•
Connect the product to the USB cable and then connect the USB end of the cable to
a powered USB port.
CHARGING INDICATOR LIGHTS
•
The bottom two (red) lights show charging status during charging. When the
charging level is below 50%, the bottom light will fade on and off. When charging is
over 50%, the bottom light will stay on and the next light will fade on and off. Once
charging is complete, the green light will turn on briefly, then switch off.
•
If your shaver does not run when you switch it on, and the bottom two leds flash
rapidly for 5 seconds, your shaver needs charging.
•
Run time from fully charged is up to 60 mins.
•
Charge time from empty is 90 minutes.
•
Do not recharge your product after each use as this will shorten the life of the battery.
•
Note: To preserve the life of your batteries, let them run out every 6 months then
fully charge.
QUICK CHARGE FEATURE
•
Your shaver has a 5 minute quick charge feature that will provide enough charge for
1 shave (3 minutes).
INSTRUCTIONS FOR USE
SHAVING
1.
Switch the shaver on by pressing the on/off button.
2.
Stretch the skin with your free hand so the hairs stand upright.
3.
Only apply light pressure on the shaving head while shaving (pressing too hard can
cause skin irritation).
8. Detail trimmer
9. Head release button
Not shown
•
USB charging cable
•
Cleaning brush
•
Head guard
•
Travel pouch
5