Baumatic BR105 Instruction Manual page 22

Use a spanner to adjust the height of the adjustable feet.
o
If your aperture has a height of 820 mm, then the adjustable
o
feet should be fully tightened.
o If your aperture has a height of 870 mm, then the adjustable
feet should be set at a height of 50 mm.
The appliance should be flush with the underside of the worktop
o
and be level. IMPORTANT: If the appliance is not level, then the
door and door seal may be affected.
A cut out must be made in the plinth/kickboard for ventilation.
o
The cut out should measure 600mm in width, and between
140mm and 90mm in height, depending on the height that you
have set your appliance.
o Insert the plinth/kickboard and then refit the grid in its original
position to hold it in place.
o IMPORTANT: Please note that as shown in the above
drawing, an appropriately sized ventilation cut out MUST
be made in the furniture plinth/kickboard.
22