Table of Contents
Advertisement
B. Install the battery pack
Charge the battery pack for at least 15-20 hours
before plugging the phone line into your phone.
1) Press in on the battery cover release and slide the cover
down until it comes off.
2) Connect the battery pack connector observing correct
polarity (black and red wires) to the jack inside the
battery compartment.
Do not exert any force on this connection. It could cause
damage to the battery or to the handset. The plastic
connectors will fit together in only one way.
Once you are certain that you have made a good
connection, then insert the battery pack into the battery
compartment. Do not pinch the wires.
3) Securely close the battery compartment cover by sliding
it up until it snaps into place.
4) Place the handset on the base. Remove the beltclip, if
attached, for face up charging.
Use only the Uniden
battery (BT-905)
supplied with your
phone. Replacement
batteries are also
available through the
Uniden Parts Department.
(See page 5.)
G E T T I N G S T A R T E D
[ 7 ]
Advertisement
Table of Contents
