Filling The Magazine; Eu Declaration Of Conformity - BEA 12100436 Manual

Device-specific additional instructions for nailer
4

Filling the magazine

Ensure that nailer and fasteners are compatible (Chap. 1) with
•
each other.
Check fasteners for proper condition.
•
Put nailer carefully down in defined safe resting position
•
(Chap. 3): The driving nose must point away from any
person. It must be impossible to unintendly actuate trigger
and/or release protection.
Pull pusher 1 backwards and engage. Insert nail strip into the
•
magazine from the rear and push forward. Disengage the
pusher and push it forward.
5 Hole finding in the wood connector
Position the tip of the tool in the hole of the wood
•
connector. Press down and trigger the tool.
6

EU Declaration of conformity

The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
R60 - 943E
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7