Summary of Contents for YIYITOOLS B084V7KGR1
- Page 1 YOU NEED TO KNOW ABOUT OUR PRODUCT 48’’ FARM JACK COMPLY WITH ASIN:B084V7KGR1 INSTRUCTIONS FOR USE. READ THIS MANUAL BEFORE USING THE FARM JACK. - Product Information Introduction - Operation Instructions - Maintenance Instruction...
-
Page 2: Specifications
Product Information Introduction SPECIFICATIONS 48" Farm Jack Maximum load:3 Ton(6600LBS) Maximum raised height: 48" SAFETY PRECAUTIONS 1. Be sure base of jack is on firm and level ground. 2. Be sure jack will not slip after load is applied. 3. Be sure lifting arm is fully under load is applied. 4. -
Page 3: Part List
Part List: 1. Top Clamp-Clevis Bolt 2. Top Clamp-Clevis 3. Steel Standard (Bar) 4. Steel Handle W/Cotter Pin 5.Handle Socket 6. Pin 7. Hex Bolt 8. Connecting Rod 9. Small Runner 10.Srew Bolt 11.Base 12.Climbing Pin Spring (2 required) 13. Climbing Pin (2 required) 14.Cross Pin (2 required) 15.Reversing Switch Cam Bar and Spring 16.Cap Screw W/Washer... - Page 4 Operation Instructions A.TO RAISE A LOAD 1. Following all safety precautions, place the foot of the jack beneath the load. Lift the Reversing Latch (20) to its' "UP" position and ensure it is locked in place, with the indentation in the Latch, firmly engaged in the notch on the Reversing Switch (18)-refer to fig.
- Page 5 1. Securely chock and stabilize the load to prevent it from rolling or shifting as you lift it (see General Safety: Chock and Block). 2. Place the jack’s base plate securely on a firm, level, and dry surface with the steel standard bar pointing straight up.
- Page 6 Chock and Block (Stabilize) A chock is a wedge for steadying an object and holding it motionless, or for preventing the movement of a wheel. Chock the wheel opposite the end being lifted. When you block a load, you secure and support a load that is being lifted. The block(s) or stabilizer(s) should have a weight capacity that is greater than the weight of the load which is being lifted.
-
Page 7: Maintenance Instructions
Maintenance Instructions If you use and maintain your farm jack properly, it will give you many years of service. Follow the mainte nance instructions carefully to keep your jack in good working condition. NEVER PERFORM MAINTENANCE ON THE JACK WHILE IT IS UNDER LOAD. Cleaning If the moving parts of the jack or the standard bar are clogged, use air pressure, water pressure, or a stiff brush to clean.