Installing The Cooktop - Summit CR2115WH Instruction Manual

a drawer installed below the cooktop. Failure to provide proper clearances and
ventilation may result in a fire hazard.
Countertop cutout dimensions are shown in the figure below. (If your cutout is
closer to 15" than 10⅝" wide, you should use one of our TK model cooktops.)
Note: When making the countertop, put a radius at the corners of the cutout (¼"
radius is typical). This will keep the countertop from cracking. Follow the
countertop manufacturer's instructions regarding the minimum corner
radius and reinforcement of corners.

4. Installing the Cooktop

The cooktop should be bedded to the countertop using a soft bedding compound
that will prevent damage if later removal for service is necessary. A very small
bead of silicone sealant should be laid around the edges of the cutout.
Place the cooktop in the cutout opening and press firmly on all sides to seal the
frame into the bedding compound.
To install TK models: For wider cutouts, use the stainless steel frame supplied
with your TK cooktop. Lay a thin bead of bedding compound along the edge of
the cutout, and then lay the frame over this, pressing down to make a good seal
once the frame is centered. The frame should be as flush with the countertop as
possible. Then place the cooktop into the opening.
Page 6