ZKTeco 1D Quick Start Manual

Quick Start Guide
1D Barcode Scanner
[1C] Version: 1.2
Due to the regular upgrades of systems and products, ZKTeco could not guarantee exact
consistency between the actual product and the written information in this manual.
Setting Code
The code scanner can set the corresponding function by reading
one or a group of special setting barcodes.
Procedure
The following are the operation steps for the manual barcode
reading mode:
1. Press and hold the barcode scanner's trigger button until the
aiming line activates and a red aiming line appears.
2. Align the red aiming line with the center of the barcode, then
move the scanner and adjust the distance between it and the
barcode to get the best reading distance.
3. The code reading is complete when the success prompt
sounds and the red lighting line disappears at the same time.
The barcode scanner transmits the decoded data to the host.
System Settings
Factory Default
Read the "Factory Default" barcode, you can reset all the proper-
ties of the scanner to the factory default state.
Factory Default
Version
Read the "Version" barcode to view the current version information
of the scanner.
Version
-1-
Sounding Settings
Read the setting barcode to turn on or o the prompt sound
when the barcode is successfully read.
Enable Decode Sound
Disable Decode Sound
Reading Mode
Manual Reading Mode
The manual reading mode is the default mode. The scanner
begins reading the code when you press the trigger button The
code reading stops after the code reading is successful or the
trigger button is released.
Manual Reading Mode
Continuous Reading Mode
In this mode, the scanner is in a continuous scanning mode, it will
automatically reads the barcode and outputs information. The
same barcode cannot be read more than once unless it is
removed and read again.
Continuous Reading Mode
-2-